Kidde 900-0114 User manual

Combination Carbon Monoxide & Smoke Alarm
– 120VAC Direct Wire with Battery Backup
– Alarm/Voice message warning system
– Permanent independent carbon monoxide and smoke alarm sensors
• Part Number 900-0114 • KN-COSM-IB
Description
The Kidde 900-0114 Combination Carbon Monoxide & Smoke
Alarm provides two important safety devices in a single unit. This
alarm includes a voice warning system that announces “Fire,
Carbon Monoxide, Low Battery or Smart HushTM Activation”. The
voice alarm eliminates any confusion and clearly warns you and
your family of a smoke or carbon monoxide danger, or if your
battery is in need of replacement. This technically advanced com-
bination alarm includes 9V battery backup providing protection
even during a power outage when many incidences occur. The
900-0114 is an easy to install alarm that is suitable for all living
areas and has a 5 year limited warranty.
Alarm Warnings
Fire: The red LED will flash and be accompanied by three long
alarm beeps followed by a verbal warning message “FIRE! FIRE!”.
The alarm will repeat pattern until smoke is eliminated.
Carbon Monoxide: Four short alarm beeps followed by a verbal
warning “WARNING! CARBON MONOXIDE!” This continues until
the unit is reset or the CO is eliminated.
Low Battery: One chirp followed by warning “LOW BATTERY”.
The red LED light will flash. This pattern will continue every minute
for the first hour. After the first hour the red LED light will flash
once every minute accompanied by the chirp sound. The “LOW
BATTERY” warning will only sound once every fifteen minutes.
Voice Hush Indication: “HUSH ACTIVATED” and “HUSH
CANCELLED” voice announcement
Peak Level Memory: If the alarm had detected a CO level of
100ppm or higher when the Test/Reset button is pressed, the unit
will announce “CO PREVIOUSLY DETECTED” to warn of the CO
incident.
Features and Benefits
•Smart InterconnectTM – Interconnects up to 24 Kidde devices
(of which 18 can be initiating).
•Battery Backup (9V battery included) – Provides protection
during power outages.
•Battery Lockout System – Minimized risk of mounting unit without
installation of battery.
•Alarm Tamper Resist – Helps deter from tampering and theft.
•Adjustable Mounting Bracket – Makes installation fast and easy.
•Peak Level Memory – Announces “CO previously detected” if
alarm had detected a CO level of 100ppm or higher since it was
last reset.
•Smart HushTM Feature – Silences nuisance alarms for approximately
10 minutes. (Smoke must be present before Smart HushTM is
activated)
•Ionization Sensor Technology – Ideal for detecting fast flaming
and other types of fires.
•Test Button Functions
–Tests the unit for proper operation
–Resets the Carbon Monoxide alarm
– Peak Level memory
•Green LED
Illuminates to indicate the unit is receiving AC power. Flashes every
5 seconds to indicate battery only mode. Flashes once per second
(until reset) to indicate that the alarm sensed a smoke or CO hazard.
Flashes every 2 seconds while the alarm is in HUSH®mode.
•Red LED
When a dangerous level of smoke or carbon monoxide is detected
the red LED will flash. If the unit
malfunctions, the red LED will flash
and the unit will chirp every
30 seconds.
NIGHTHAWK
TECHNOLOGY
World’s Most Accurate
Carbon Monoxide Alarm*
TM
Voice Warning
Warns of hazard by announcing “Fire, Fire” or “Warning, Carbon Monoxide”.
Peak Level Memory
Alerts user when the unit has detected CO concentrations of 100ppm or higher.
Smart HushTM
Silences the unit during nuisance alarm situations.
(Smoke must be present before hush is activated)
Two LED’s
•Red – Alarm mode.
•Green – Indicates that AC power is present.
Test/Reset Button Functions
•Tests the units electronics and resets the unit during CO alarm.
•Activates Hush Feature and Peak Level Memory.
Adjustable Mounting Bracket
Allows for easy installation and alignment.
*Based on accuracy claims of major manufacturers
Alerts user to replace CO alarm
after 7 years of operation
NEW
FEATURE:

1394 South Third Street, Mebane NC 27302
1-800-880-6788 • www.kiddeus.com
Combination Carbon Monoxide
& Smoke Alarm Part Number 900-0114 Unit Number KN-COSM-IB
Installation of Smoke Alarm
The combination alarm should be installed to comply with all
local codes having jurisdiction in your area, Article 760 of the
National Electric Code, and NFPA 72. Make certain all alarms are
wired to a single, continuous (non-switched) power line, which is
not protected by a ground fault interrupter. A maximum of
1000 ft. of wire can be used in the interconnect system. Use
standard UL listed household wire (18 gauge or larger as
required by local codes).
Technical Specifications
Part Number: 900-0114
Unit Number: KN-COSM-IB
Power Source:
120VAC, 60Hz 25mA max per alarm
9V battery backup
Smoke Sensor: Ionization
CO Sensor: Electrochemical
Audio Alarm: 85dB at 10ft
Temperature Range: 40˚F (4.4˚C) to 100˚F (37.8˚C)
Humidity Range: 5%-95% relative humidity
Size: 5.75” in diameter x 1.7” depth
Weight: 1lb
Wiring: Quick connect plug with 8” pigtails
Interconnects: Up to 24 Kidde devices
(of which 18 can be initiating)
Warranty: 5 year limited
Ordering Information
UPC: 0-47871-00114-9
Part Dimensions Case/ Layers/ Skid
Number I 2 of 5 Pack Quantity (w x d x h inches) Weight Skid Skid Weight
900-0114** N/A Individual 5.8 x 2 x 6.2 1lb N/A N/A N/A
900-0114-02 200 47871 00114 3 Master Pack (6 units) 7 x 13 x 7 7.65lbs 100 5 765lbs
**Not for sale by individual unit
5.75" 1.7"
FUSE OR CIRCUIT BREAKER
BLACK
WHITE
RED
L
N
First
Alarm Additional Alarms
MASTER PACK
6
1
UNIT
Distributed by: