Kiddicare Triple User manual

Triple
Instruction Manual
IMPORTANT PLEASE READ THESE INSTRUCTIONS
CAREFULLY BEFORE USING THIS PRODUCT
KEEP FOR FUTURE REFERENCE

Safety Warnings Getting to know your Stroller
Hood
Secondary release
lock
Front swivel
wheel levers
Shopping
basket
Hood adjustment
catch
Harness
Storage clip
Primary release
locks
Brake levers
Calf rest
Backrest release
toggle
Thank you for choosing Kiddicare. To ensure that your stroller is used in accordance with
these instructions, please read them fully.
This stroller conforms to EN 1888:2012 and is guaranteed for 24 months from the date
of purchase against manufacturing defects. If you have any problems with this product
please contact Kiddicare.com
Your child’s safety may be affected if you do not follow these
instructions.
WARNING: A child’s safety is your responsibility
WARNING: Ensure that all locking devices are engaged before use
WARNING: Never leave your child unattended
WARNING: To avoid injury ensure that your child is kept away when
unfolding and folding this product
WARNING: Do not let your child play with this product
WARNING: Always use the restraint system
WARNING: This product is not suitable for running or skating
WARNING: Any load attached to the handles will affect the stability
of the pram / pushchair
• A basket is provided for the carriage of other items up to a maximum
permissible weight of 3 kg. Where a hood parent pocket is provided,
an additional 1kg maximum permissible weight can be used within this
• This stroller is intended to carry three children from birth and up to a
maximum weight of 15kg
ROUTINE CARE & MAINTENANCE
- This stroller requires regular maintenance by the user
- It may be unsafe to use replacement parts or accessories e.g. child
seats, bag hooks, rain covers, etc, other than those approved by the
manufacturer or distributor.
- For cleaning, use only a mild detergent and warm water
- DO NOT USE BLEACH
- DO NOT USE any abrasive substances
- From time to time, check your stroller for loose screws, worn parts,
torn material or stitching. Replace or adjust the parts as needed.
Due to constant updating and improvements, some components may occasionally differ slightly from the images shown
in these instructions. We reserve the rights to change the specications of any products without prior notice.
If you need any assistance please contact Kiddicare.com.
23
www.kiddicare.com www.kiddicare.com

Opening your Stroller
To open your stroller release the two storage clips on the stroller (g.1 & 2).
Lift the handles away from the wheels (g.3).
Using your foot push down on the three primary release locks at the back of the stroller
(g.4), one at a time. Ensure the locks click into place (g.5 & 6).
Folding your Stroller
Before attempting to fold your stroller
- The front wheels should be locked in place
- The baskets and seat units should be empty
- The hoods should be folded
- The seats should be fully upright
To fold the stroller, release the three primary locks, at the back of the stroller, one at a
time, by pulling away from the stroller and then lifting using your hand or foot (g.7).
Next, using your foot press down on the secondary lock at the right hand side of the
stroller (g.8). Then push the handles forwards and down towards the front wheels
(g.9), until completely folded (g.10). Engage the two storage clips onto the front legs
of the chassis (g.11 & 12).
g. 1
g. 4 g. 10g. 5 g. 11
g. 7
g. 2
g. 6 g. 12
g. 8
g. 3 g. 9
WARNING: Ensure that all locking devices are engaged before use
2. Lift
1. Pull
Press
Press
Press
“Click”
45
www.kiddicare.com www.kiddicare.com

Fitting and Removing the Front Wheels
g. 13 g. 14 g. 15
Using the Front Swivel Wheels
To lock the swivel wheels, rst ensure the front wheels are facing forward inline with the
chassis, then lift the lever up (g.16).
To put the wheels in swivel mode, push the lever down on the front of each front wheel
(g.17 & 18).
g. 16 g. 17 g. 18
Adjusting the Backrest
Applying the Brakes
g. 19 g. 20
Release
Lock
To lock the brakes fully, push down on each brake lever using your foot (g.19).
To release the brakes, lift each brake lever using your foot (g.20).
Apply the brake before putting your child into the pushchair.
Apply the brake when the pushchair is stationary.
To recline the backrest, press the button on the backrest release toggle and pull away
from the seat to the desired height (g.21). Lower the seat to rest on the toggle (g.22).
To put upright, grip the sides of the toggle with one hand, and the strap with the other
hand and slide the toggle up the strap to the desired height (g.23).
g. 21 g. 22 g. 23
Press
Lock Release
To t the front wheels, push the wheels onto the front legs until they click into place
(g.13 & 14).
To Remove, squeeze both clips, whilst pulling the wheel off the leg (g.15).
67
www.kiddicare.com www.kiddicare.com

g. 30
g. 33
g. 31
g. 34
g. 32
g. 35
Press
Waist
Strap Crotch
Strap
Shoulder
Strap
Clasp
g. A
Harness
Positions
Lower
Inner
Inner
Outer
Outer
Outer
Upper
To fasten the harness, insert each waist strap fastener
through the loop on each shoulder strap (g.30). Then
insert both waist strap fasteners into the clasp on the
crotch strap (g.31 & 32).
To release the harness, squeeze each of each clips in the
centre of the harness and pull away from the clasp, one at
a time (g.33).
Adjust the harness length using the buckles on each strap
(g.34).
‘D’ Ring
The ‘D’ rings highlighted are provided for tting a separate
harness complying with BS 6684 (g.35).
When using the safety harness from birth, it may be necessary to use the lower holes for
the shoulder strap and the inner holes for the waist straps and crotch strap.
Higher holes for the shoulder strap and outer holes for the waist straps and crotch strap
should be used when your child is of a suitable size. (See g.A)
WARNING: Always use the crotch strap in combination with
the waist belt
Fitting and Removing the Hood
Adjusting the Hood
g. 27 g. 28 g. 29
To fold the hood, pull the hood adjusters up on both sides of the hood, as shown above.
Using the Harness
g. 24 g. 25 g. 26
To t the hood, place the hood on the chassis, inline with the seat unit. Clip the hood
catches onto each side of the chassis (g.24).
Then to prevent the hood slipping down pull the elastic around the chassis and loop over
the peg on the side of the hood (g.25).
To remove the hood, unloop the elastic, then lift the hood catch away from the chassis
(g.26).
89
www.kiddicare.com www.kiddicare.com

g. 36
g. 39
g. 37
g. 40
g. 38
g. 41
Adjusting the Calf Rest
Fitting the Rainshield
Press
Press
To adjust the calf rest press the levers either side of each seat and lift or lower to the
correct position. The calf rests are independently adjustable.
WARNING: When using the rainshield, regularly check your child has adequate
ventilation and is not overheating.
Unless it is raining, the rainshield should be removed.
To t the rainshield, place the rainshield over the stroller and allow the rainshield to
drape over the front of the stroller.
Secure in place using the press studs at both sides of the rainshield (g.39) and clips
onto the front legs of the stroller (g.40 & 41).
10
www.kiddicare.com www.kiddicare.com

www.kiddicare.com