Kidi Race Police Car User manual

Owner’s Manual
Item # 2411
BROOKLYN, NY 11205
www.kidirace.com
© 2019 KIDIRACE
For Ages
3+
For Ages
3+
SAFETY
• Operate only under adult supervision.
• Select a safe place to operate this car. Never drive on or close to a street.
• Keep fingers, hair and loose clothing away from tires, hubs and motor while in
operation.
• Avoid operating when controller battery is low.
• Only operate within your line of sight.
• Do not operate in the rain or drive through standing water.
• Do not over charge the battery.
• Packaging should be kept as it may contain important information.
• Non-rechargeable batteries are not to be recharged.
• Different types of batteries (Alkaline, standard - carbon-zinc, rechargeable – nickel-cad-
mium) or new and used batteries are not to be mixed.
• Exhausted batteries to be removed from the toy.
• The supply terminals are not to be short circuited.
• All packaging to be removed before giving to child.
• WARNING: strangulation hazard – long cord.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.

OPERATION
Controller Batteries
CAR ALIGNMENT
POWER
Battery Charging
Power
Switch
Power
Indicator Light
Forward
Reverse
Power On/Off
Left
Right
Car
Power
Switch Controller
Power
Switch
Engine
Start
Button
Engine
Start and
Siren Button
Alignment
Lever
To power on, locate the on/off switch on the front controller and switch that to the on
position. Next locate the on/off switch on the bottom of car and switch that to the on
position. Press the right top button on the controller to start engine.
Note: Always turn the controller on first.
Press the engine start and the engine sound will begin. Press up on the remote toggle
to move the car FORWARD. Press down remote to move the car BACKWARD.
Push remote toggle right to TURN RIGHT while moving. Push remote toggle left to
TURN LEFT while moving.
To keep the car driving straight locate the
alignment level on the bottom of the car.
Move the lever in the direction the car
needs to go in order to drive straight.
Make small adjustments.
Battery Cover
Screw
4 AA
Batteries
On
On
Remove the battery cover screw located on the back of controller and press the
battery door release tab. Open the cover and insert (2) AA batteries as shown. Close
the cover and re-tighten the battery cover screw. Note: The battery terminals must be
positioned as shown.
Note: Carefully remove all content from the packaging.
Make sure the power switch on the car is set to the OFF position.
Locate the battery compartment on the bottom of the car, and loosen the screw on
the battery cover and press release tab on cover.
Insert 4 AA batteries correctly by matching the + and – polarity markings as
indicated.
Replace the battery compartment cover and tighten screw.
Battery
Cover
Release
Tab
Battery Cover
Screw
Battery
Cover
Release
Tab
2 AA
Batteries