King gates IDEALED Technical specifications

1234
BLUEGREEN
IDEALED
EN Instructions and warnings for
installation and use
Made in Italy

EN
IDEALED is an LED flasher unit for indicating the hazards
associated with the use of automation devoices for gates,
garage doors and road barriers; any other use is forbidden and
inappropriate.
IMPORTANT WARNING
Warning! The installation of the product has to be made by
qualified personnel, under the laws and rules in force and
following the instructions of this handbook.
It is important to respect the following warnings:
• Check that the voltage of the product is compatible with the
one on the clamp of the control unit used for the connection
of the flashing light.
• Before making the electrical connections, cut electricity off the
control unit.
REFERENCE OF MARKING SYMBOLS:
The label affixed to the product bears the following symbols that
have the following meaning:
/ AC or DC supply voltage
protection against electric shock guaranteed by
reinforced insulation
TECHNICAL FEATURES
IDEALED-WR
Power supply 24 ÷ 300V
24 ÷ 230V 50/60Hz
Consumption
1,15W (230V - 5mA)
1,15W (115V - 10mA)
0,7W (24V - 30mA)
0,9W (30V - 30mA)
Intermittence automatic
IDEALED-24V
Power supply 22 ÷ 36V
15 ÷ 26V 50/60Hz
Consumption 1W (24V )
Intermittence no
COMMON FEATURES
Insulation class II
Protection degree IP44
Working temperature -20 ÷ +60 °C
Dimensions 132 x 112 x 81 mm
PRELIMINARY CHECK
• Check the packaging integrity before opening it and, once
open, check the product integrity inside it
• Check that the place chosen for the installation grant the user
total visibility of the flashing light from a long distance
• Check that the surface chosen for the installation is strong
and grant a steady fixing
mATTENZIONE: WARNING: avoid the surfaces where
seepage in case of rain is possible.
INSTALLATION
1. To define the points envisaged for installation, bearing in mind
that it is necessary to fix the flashing unit onto a flat linear
surface
2. Define the groove path for the electric cables
3. Open the case of the flashing light and use the base to mark
the fixing holes
4. Fix the base and connect to the terminal board
1 - 2 Power supply
3Antenna shield
4Antenna
mWARNING: use a cable suitable for external use with
a minimum section of 2x0,5 mm2and a maximum one of
2x1,5mm2
mWARNING: for the antenna use a cable RG58 or RG174
6. Seal the holes of the plugs with silicone to avoid seepage of
water inside the device
7. Close the box with the special screws
DISPOSAL
As for the installation, the disposal of the product at the end of its
effective life must be performed by qualified personnel.
This product is made of various types of material, some of which
can be recycled while others must be disposed of.
Enquire about the recycling or disposal systems available for this
product category in compliance with regulations locally in force.
EU DECLARATION OF CONFORMITY
The manufacturer V2 S.p.A., headquarters in Corso Principi di
Piemonte 65, 12035, Racconigi (CN), Italy
declare that the products
IDEALED
conforms to the essential requirements established in directives:
2014/35/UE low voltage directive
2014/30/EU electromagnetic compatibility directive
RoHS-3 2015/863/EU
Racconigi, 01/06/2020
Legal representative, V2 S.p.A.
Sergio Biancheri