King Tony 9TY1342-02 User manual

Enjoy your work
ENGINE CRANE
OPERATION MANUAL
NO.9TY1342-02
2

SAFETY INSTRUCTIONS
OPERATION
WARNING
• Study, understand, and follow operation manual and safety precautions before using this device.
• Failure to heed these warning may result in damage to crane and /or resulting in personal injury or
property damage.
• Always use crane in pairs on a hard level surface capable of sustaining the load.
• Do not overload the crane beyond it’s rate capacity of each specified boom position.
• Move load slowly and smoothly to avoid uncontrolled swinging and drop suddenly during transport.
• Load and boom must in lowest possible position before removing.
• No any alteration shall be made to the engine crane.
• Visually inspect device for damage before each use.
Front legs must always be locked in the down position before applying a load and raising the boom
(figure 1 & 2).
• Before moving the crane, the brake of rear caster should be in released position.
• When the crane is still, the brake should be in tightened position.
• Boom must be in the fully lowered position before raising legs and ahould be locked in place (figure
3).

ASSEMBLY AND PART LIST
Part
Description
Qty
1Leg 2
2Base 1
3 Upright mast1
4 Hydraulic ram 1
5 Pump handle 1
6 Boom 1
7 Handle 1
8 Swivel caster 3" 2
9 Bolt M8x20 8
10 Spring washer 812
11 Nut M8 8
12 Hook 1
13 Bolt M14x90 3
14 Spring washer 14 5
15 Nut M14 5
16 Detent pin 2
17 R-clip 3
18 Boom pin 1
19 Mast brace 2
20 Bolt M16x100 3
21 Spring washer 16 3
22 Nut M16 5
23 Boon extension 1
24 Bolt M16x75 1
25 Washer 162
26 Bolt M8x1102
27 Bracket2
28 Spring washer 18 3
29 Nut M18 3
30 Bolt M14x1102
31Nut M102
32Spring washer 102
33 Wheel 2
34 Bolt M10x40 2
35 Washer 142
36 Front wheel 2
37 Bushing 2
38 Collar 4
39 Bolt M16x90 1
40 Bolt M8x10 4
41Bolt M18x1101

899TY1342-02-KT 297x210mm
www.kingtony.com
customer service e-mail : [email protected]