KingShield LEDFLP10 User manual

Installation Instructions for
LED R charg abl Work/Flood Lights
- LEDFLP10 & LEDFLP20
PLEASE ENSURE YOU READ THESE
INSTRUCTIONS BEFORE COMMENCING
ANY INSTALLATION
IMPORTANT
Both the 8W (LEDFLP10) and 16W (LEDFLP20) fittings are
porta le/rechargea le SMD flood lights. The internal rechargea le
and cordless operation allows for complete porta ility.
• Do not look directly at the LED lights, this may cause eye injury.
• To reduce the risk of electric shock, do not su merge the units or
its accessories in any liquid. Units are water resistant (IP65) ut
NOT waterproof.
• Store unit in a clean dry place.
• Protect LED lens from damage and scratching.
CHARGING THE BATTERY
Mains Charg r:110V-240V AC Car Charg r: 12V DC
1. Plug the DC output plug from either adapter into the DC IN
PORT of the unit and then plug the 110-240V AC or the 12V DC
adapter into the appropriate electrical socket (depending on
which charger is eing used).
2. Unplug chargers after a full charge is achieved (approx 5hours
with 110-240V mains charger).
3. Can also e operated directly from the mains charger. (When
fully discharged the attery may require 5minutes of charging
to restart operating with 100-240V AC charger).
WORK LIGHT OPERATION
.
1. To attach it to the BASE, remove the MOUNTING BOLT and
place the light on top, aligning the hole in the mounting racket
to the hole in the ase. Replace the olt and tighten securely.
2. Toggle switch for ON/OFF operation: (l) for ON and (O) of OFF.
3. Adjust the angle of the light y grasping the PADDED HANDLE
and tilting the face of the flood light up and down or swiveling
right to left.
LEDFLP10 20 Ins.qxp_Layo t 1 13/10/2014 11:24 Page 1

GUARANTEE
WEST ROAD . HARLOW
ESSEX . CM20 2BG . UK
sal s@gr nbrook.co.uk
www.gr nbrook.co.uk
Issue No: 703805
TECHNICAL INFORMATION
Power Rating: 230V AC 50Hz
Wall Charger: Input: 230V AC-50/60Hz
Output: 5V DC - 500mA
Car Charger: Input: 12-24V DC
Output: 5V DC - 500mA
IP Rating: IP65
Led Power (LEDFLP10)
Consumption: 8W, 75 lm/W
Led Power (LEDFLP20)
Consumption: 16W, 75 lm/W
Battery Type:
LEDFLP10 1x 3.7V 3600mAh Lithium
Battery (supplied)
LEDFLP20 1 x 3.7V 5400mAh Lithium
Battery (supplied)
Charging Time: 5hours(approx)
LEDFLP10 Dims (with ase): 145 x 167 x 240mm
LEDFLP20 Dims (with ase): 215 x 185 x 285mm
Conforms to: EN60950-1, EN55015 &
EN61547
PLEASE KEEP THESE
INSTRUCTIONS SAFE FOR
FUTURE REFERENCE
Your KingShield LED Rechargea le Work/ Flood Lights
are guaranteed for 3 years from the date of purchase.
This does not affect your statutory rights.
LEDFLP10 20 Ins.qxp_Layo t 1 13/10/2014 11:24 Page 2