Kitchensource 88 5549 16 User manual

IMPORTANT NOTE
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damage occurring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure a
completed product as it was designed.
Part List
Hardware List
88 5549 16
Crescent Hill
Student Desk
Tools required for assembly : Phillips screwdriver Tools recommended for assembly : Level
Hex Wrench
1 Pc.
Small Hex Wrench
1 Pc.
M6x60
Head Cap Bolt
8 Pcs.(+1 extra)
Flat Washer
8 Pcs.(+1 extra)
Spring Washer
8 Pcs.(+1 extra)
Pull Handle
1 Pc.
M3x8
Wood Screw (short)
6 Pcs. (+1 extra)
M3x30
Wood Screw (long)
6 Pcs. (+1 extra)
M4x25
Machine Screw
2 Pcs.
A.
Top Unit
1 Pc.
B.
Leg
1 Pc.
C.
Leg
1 Pc.
D.
Leg
1 Pc.
E.
Leg
1 Pc.
F.
Stretcher
1 Pc.
G.
Stretcher
2 Pcs.
H.
Keyboard Front
1 Pc.

Assembly Instructions 2
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten up all the bolts until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
*After assembly item must be level to work properly. Use the included adjustable levelers to level.
STEP 2
Place Top Unit (A) upside down on a soft cloth.
Attach Legs (B), (C), (D) and (E) to
Top Unit (A) with Flat Washers, Spring Washers
and Head Cap Bolts.
Tighten Head Cap Bolts only half way.
(See Figure 2)
Attach Stretchers (F) and (G) to the unit
with Wood Screws (long).
Tighten Head Cap Bolts completely.
A
A
F
G
G
B
CD
E
Figure 1
Figure 2
/3
STEP 1
Remove outside drawers from Top Unit (A).
Remove the keyboard from Top Unit (A) by pushing the plastic lever on its’ left side up, pushing
the plastic lever on its’ right side down and pulling the keyboard open slowly.
(See Figure 1)
Wood Screw (long)
Head Cap Bolt
Flat Washer
Spring Washer

Assembly Instructions 3
STEP 3
Attach Keyboard Front (H) to keyboard with Wood Screws (short).
Attach Pull Handle to Keyboard Front (H)
with Machine Screws. (See Figure 3)
STEP 4
Turn the unit over to its’ upright
position.
Remove the Pull Handles that are
installed on the inside of the outside
drawers and re-install them on the
outside of the drawers. (See Figure 4)
Slide the keyboard and the outside drawers into position.
Level the unit by adjusting the adjustable levelers
on the bottom of the legs. (See Figure 5)
Note : Unit must be level to work properly.
H
H
Wood Screw (short)
Figure 3
Figure 4 Figure 5
/3