Kitchensource Home Styles 88 5062 941 User manual

Home Styles Consumer Assistance : www.homestyles-furniture.com,
[email protected], 888-680-7460, 877-831-0319
Part List
Tools recommended for assembly : Level
Hardware List
IMPORTANT NOTE.
Carefully remove all the parts from the carton and put
them individually on a soft cloth to prevent scratches
or other damage occurring to the parts.
We have taken great care in the design of this
product and request that you carefully and strictly
follow our assembly instructions to ensure
a completed product as it was designed.
88 5062 941
Kitchen Island
B.
Side Frame
2 pcs.
C.
Support
2 pcs.
D.
Shelf
1 pc.
E.
Shelf
1 pc.
F.
Shelf
1 pc.
For assembly also need carton 88 5062 942 or 88 5062 943
Hex Wrench
1 pc.
Small Wrench
1 pc.
M6x38
Tapered Head Cap Bolt
(long)
2 pcs. (+1 extra)
M6x15
Head Cap Bolt
16 pcs. (+1 extra)
Spring Washer
8 pcs. (+1 extra)
Flat Washer
8 pcs. (+1 extra)
M6x19
Tapered Head Cap Bolt
8 pcs. (+1 extra)

Assembly Instructions 2/3
IMPORTANT
* Please keep Hex Wrench in a safe place as you may need to tighten up the Head Cap Bolts in the future.
* Do not tighten up all the bolts until each part is properly assembled.
* Use a soft cloth between these parts and the floor.
* After assembly, item must be level to work properly. Use the included adjustable levelers to level.
Figure 1 Figure 2
STEP 2
Attach Side Frame (B) to unit with
Tapered Head Cap Bolts
and Head Cap Bolts.
D
E
F
Tapered Head Cap Bolt
Head Cap Bolt
B
STEP 1
Attach Shelves (D) and (F) to
Side Frame (B) with Head Cap Bolts.
(See Figure 1)
Attach Shelf (E) to unit with
Tapered Head Cap Bolts
at desired level. (See Figure 2)
Tighten all Bolts only half way.
Tapered Head Cap Bolt
Head Cap Bolt
B

Assembly Instructions 3/3
STEP 3
Turn the unit to its’ upright position.
Attach Supports (C) to unit with
Tapered Head Cap Bolts (long).
Tapered Head Cap Bolt (long)
C
C
Head Cap Bolt
Figure 3
A
Flat Washer
Spring Washer
STEP 4
Attach Top (A) to unit with Flat Washers, Spring Washers and
Head Cap Bolts.
To level the unit, adjust the adjustable levelers on the bottom of unit.
(See Figure 3)
Tighten all Bolts.
Note: Unit must be level to work properly.