Klëarvue Cabinetry 478-3917 User manual

1
Wire Rack x1
Euro Screw x6
SS-10.1033
Left Glide x1
SS-20.1089
Rack Mounting
Screw x4
SS-10.1030
Right Glide x1
SS-20.1090
Door Mounting
Screw x6
SS-10.1029
Template x1
SS-20.1100
NOTE: Rack Mounting Screw is
small and is packed with Door
Mounting Screw
To nd all Klëarvūe® Cabinetry installation instructions and installation videos, visit www.klearvuecabinetry.com
Instructions for SKUs 478-3917, 478-3918
TIERED PULL-OUT ORGANIZER
QUESTIONS?
Contact Customer Care
1-800-721-4191
Monday – Friday 8-5 Central Time
KIT INCLUDES:

2
3rd Hole
Mounting
Hole
Side of
Door
Bottom of
Door
NOTE:
The 12” Tiered Pull-Out Organizer (478-3917) is intended for use in a 12”W x 24”D x 30”H Klëarvūe®
Cabinet (478-0004).
The 9” Tiered Pull-Out Organizer (478-3918) is intended for use in a 9”W x 24”D x 30”H Klëarvūe®
Cabinet (478-0001).
STEP 1:
● Line up the holes of the glides (SS-20.1089 / SS-20.1090) with the 3rd set of holes in the cabinet box
(counting up from the bottom) and secure with the euro screws (SS-10.1033).
STEP 2:
● On the back of the cabinet door, align the template (SS-20.1100) with the bottom and side edge of the door
as shown below.
● Make a mark for the bottom mounting screw using the template. You will be using the hole that is marked
with a circle around it on the template.
● Repeat for the opposite side of the door.

3
6”
Bottom
Mounting Hole
Mark
STEP 3:
● From the mark made for the bottom mounting screw, measure up 6” and use the notch in the template
aligned on the side of the door (see image below) to mark the second mounting hole on each side of the door.
● From the mark made for the second mounting screw, measure up 6” and use the notch in the template
aligned on the side of the door (see image below) to mark the third mounting hole on each side of the door.
● Using a 1/16” drill bit, drill a short pilot hole at each mounting location. DO NOT drill through the door.
STEP 4:
● Mount the door front to the wire rack using the door mounting screws (SS-10.1029).

4
STEP 5:
● Fully extend the glides, place wire rack and attach to glides with the rack mounting screws (SS-10.1030).