4. Basic Buon Operations
Power on: Press multifunction button for 4 seconds.
Blue LED ashes 2 times. Earphones turn on.
Power off: Press multifunction button for 4 seconds.
Red LED ashes 2 times. Earphones turn off.
Volume adjust: Each press on “Volume up” or “Volume
down” buttons, one level of volume changes. When
Volume reaches Max or Minimum. “Tick” reminding sound
occurs.
Play/Pause: Short press multifunction button to pause
music. Press it again, music continues.
Previous: in standby mode, Long press 2 seconds
“Volume down” button, track skips back.
Next: in standby mode, Long press 2 seconds
“Volume up” button, track skips forward.
Answer call:Short press multifunction button
to answer the phone call. 6
End call: Short press multifunction button to end call.
Reject call: Long press the multifunction button for
2 seconds to reject a call.
Last number redial: in standby mode,continuously press
earphone multifunction button twice to redial the last
number.
Snapshot: Short press the “Snapshot” button can
achieve snapshot action.
Baery Status: When earphones connect to iOS
devices show the headphone battery power status on
the upper right hand corner.
Charging: New earphones have enough power for pairing
and dialing out multiple times.When battery is low,
please charge via USB cable for 2 hours. Red LED
remains on during charging, when blue LED is
on this means charging is complete.
7
Pairing with 2 phones or other devices at the same
time: These earphones can support 2 device
multi-connection. It can pair with 2 mobile phones
simultaneously, taking the call from either. (1) After
completing pairing with the rst phone, turn off the
rst phone and the earphone in sequence, then re-do
the pairing procedure with another phone. (2) Once
nished the pairing, restart the rst phone and nd the
earphones “KLIM Pulse” in the bluetooth list to connect
to it, then two phones can use with there earphones at
the same time.
9
6. Warning
1. You must charge the earphones with the Micro USB
charger cable provided, if you use any other charger it
may damage your earphones, should you do so it is at
your own risk.
2. You must charge the earphones if they have not been
used for more than 12 months.
3. The earphones contain a magnet therefore it is
advised to seek medical advice should you have a
pacemaker or wear an ICD.
10
5. Pairing (One pair of earphones supports connecting 2
devices)
IMPORTANT: For the 1st pairing press the power button
for 7 seconds (even once the device is on).
Pairing with a phone or other device: (1) Make sure the
headphone is powered off. (2) Press and hold the
multifunction button for 7 seconds to enter pairing
mode. (3) Red LED & Blue LED ashes alternately,
activate your phone or device’s Bluetooth function and
search for earphones. (4) From the list of found devices
on your mobile phone, select the headphone “KLIM
Pulse” to connect to it. (5) Follow the instructions and
enter “0000” as PIN if the mobile phone asks you to do
so. (6) The earphones or device can be used to play
your phone music or dial a call, etc.
8
7. Information
1. The ear tends to enjoy familiar sound, which means
that when you get new earphones you may not like the
sound at rst. We strongly advise you to give it 30
minutes and you should enjoy this new sound.
2. Some devices might recognize the earphones as a
keyboard. If this happens, go to Settings > Bluetooth,
click on the icon beside KLIM Pulse and uncheck the
option “Input Device”.
11
