Klipsch RSB-6 Use and care manual

The Dolby Digital LED will light up when the
firmware update has started.
RSB-6 SOUND BAR FIRMWARE UPDATE INSTRUCTIONS
Copy the “.mdu” update file to an empty
USB flash drive.
Plug the power cord into the sound bar.Insert the USB drive into the USB port on the rear
of the sound bar.
Unplug the power cord from the sound bar.
Soundbar
3 4
2
1
6
5Press the source key to begin the firmware update.
HDMI 1 HDMI 2 HDMI 3 TV DIALOG NIGHT

As the update installs - the Virtual Surround Mode
LED will light up, then the Dialog LED, then the
Night Mode LED. The update will be complete once
all 4 LED’s are lit.
RSB-6 SOUND BAR FIRMWARE UPDATE INSTRUCTIONS
Problems or questions?
Enter this url into your web browser -
http://support.klipschgroupinc.com/
...and click on the “Open a New Ticket” button.
Remove the USB flash drive from the sound bar.
Unplug the power cord from the sound bar.
9Plug the power cord into the sound bar. Your
sound bar firmware is now up to date and your
sound bar should operate normally.
10
8
Soundbar
7