KMC Controls KMD-5569 User manual

KMD-5569: SETUP FOR THE U.S.
ROBOTICS 36K or 56K MODEM
1. Unpack the modem and set the dip switches
on the back as follows:
Switches 3, 4, & 8 down (ON)
All other switches up (OFF)
2. Connect the modem to the computer using a
RS-232 cable.
5. Click Cancel to remove the Connection Description window.
Installation Guide
Setup
4. Open HyperTerminal from your windows Desktop by clicking Start --> Programs -->
Accessories --> Communications --> HyperTerminal.
Configuration
3. Plug the modem power adapter into the
modem. Turn the modem on. When the
modem is on, turn on the computer.
CAUTION: Check to ensure you are using
the proper power supply.
Before You Begin
The KMD-5569 modem comes factory configured and ready for use. The modem should NOT be
reconfigured unless the original settings have been lost.
CAUTION: Do NOT use the USRobotics CD to configure your modem.

6. From the menu bar at the top of the window, click File --> Properties.
7. Click on the drop down box in the "Connect Using" field and select "U. S. Robotics 56K".
NOTE: If there is more than one USRobotics modem, the KMD-5569 will be identified by the
letters "EXT" on the end of its file name.
NOTE: If USRobotics drivers have never been installed on your PC, you will not see a selection for
the KMD-5569. Instead, select the Com Port (e.g. COM1) that you used to connect the
modem to the PC.

8. Click OK.
9. Type "AT&F" to fetch the factory configuration and press enter. The screen should confirm
communications by displaying "OK" for each entry.
NOTE: Make sure the screen confirms each line with "OK" when you press enter.
10. Type the following lines IN ORDER and press enter after each one.
"AT&K0" ————— Data compression disabled.
"AT&N10"————— Sets Baud to 19,200 or ("AT&N6" to set for 9600 baud).
"ATS00=001" ————Number of rings to auto answer, 000 indicates auto answer is OFF.
"AT&W"—————— Writes to first stored Profile NVRAM 0.
"AT&W1"————— Writes to second stored Profile NVRAM 1.
(see CAUTION above)
CAUTION: You will not see the entries in Steps 8 & 9 as you type. Be very careful to enter
commands EXACTLY as they appear between the quote marks. The screen will display
"ERROR" if you enter a command it does not recognize.

11. Type "ATI5" to view the configuration in the first stored profile (AT&W). Verify that the
highlighted parameters match your first three entries in Step 10.
12. Hit any key to scroll down and confirm that the second profile (AT&W1) matches.
13. To exit the program, first hang-up by clicking the telephone icon in the Tool Bar at the top of the
page, then click File --> Exit from the menu bar.
You may now test the connection using WinControl XL.
NOTE: The "AT" prefix does not appear on screen with the data values.

When using HyperTerminal (see Step 4) and a US Robotics modem in terminal mode you can type
"ATI6" after connecting to see the statistics for the last attempted or successful connection.
EXAMPLE:
887-019-01A
KMC Controls
P.O. Box 497
19476 Industrial Drive
New Paris, IN 46553
U.S.A.
TEL: [phone]
FAX: [phone]
E-mail: [email protected]
Diagnostic