?
FAQ’s
Q: Most Bluetooth pairing issues are a result of swapping
Bluetooth sources before terminating the current
connection. This sometimes causes the Timpani to remain
connected, or paired, to the previous audio device. That
said, the Bluetooth sync needs to be reset on your Timpani
speaker, as well as on your compatible Bluetooth device.
A: To disconnect Bluetooth connection on the KW101, press
and hold the BLUETOOTH PAIR button for 3 seconds. The
blue LED light on the top of the unit will flash, indicating that
the KW101 is searching for a compatible Bluetooth device.
Next you will want to go into the Bluetooth settings on
your compatible Bluetooth device and clear “Forget This
Device” from the list (and any other Bluetooth-enabled
device you may have previously paired with the KW101).
Now with the KW101 powered on, try searching for
Bluetooth compatible devices under the Bluetooth settings
menu of your Bluetooth-enabled device. After a few seconds
it should detect the “
Knit Timpani
”, at which time you can
select “
Knit Timpani
”and establish a new connection.
Q: If I hear distortion, what should I do?
A: Lower the volume on your Timpani speaker, and increase the
volume on your audio source.
Q: What if I hear Intermittent sound?
A: Move the audio source and the speaker closer together,
within 30’ of each other.
Q: I cannot play audio via Bluetooth.
A: Confirm your device is A2DP Bluetooth compatible.
Ensure that both your Bluetooth device and speaker
are not connected to any other devices.
Unpair speaker from your Bluetooth device (check with your
device manufacturer for more information about Bluetooth
pairing.) then re-pair following the steps in the section
BLUETOOTH PAIRING.
