KoamTac SKXPro User manual

*PH0 screwdriver is necessary to complete assembly/dis-
assembly.
*Make sure that the phone is off
before assembly

SKXPro_XCoverPro_AS_20201118
1. Remove the screws on both sides of the scanner. (F) Next,
remove the top cover by pressing the grooves on both
sides of the SKXPro with your finger and pull the top
cover away from the SKXPro. (G)
1. Slide the hand strap’s left elastic band through the left
strap hole of the SKXPro. Use pin or sharp tool to fasten
the left elastic band to the plastic tab inside the SKXPro. (I)
Repeat the process with the hand strap’s right elestic band.
2. Flip the top cover back. After placing the sliding pad
on the XCover Pro screen as shown in the figure,
remove the XCover Pro by pushing up the sliding pad
with both fingers. (H)
*Make sure that the phone is off
before assembly
3. By adjusting the lower hook and loop section of the hand
strap, the length of the hand strap can be tailored four
ways to better suit the user. (K)
K
Loose
Loosest
Tightest
Tight