4.Product Debugging
Open Connect external power instrument to power on.
Zero clearing Press (0) for zero clearing
SET Press（SET）to enter
No weight learning PN1
Enter demarcated parameter
setting
[----]
[1111]
prompt for entering password for front instrument
Enter password: 1111,Press () () () to shift and select: password is
correct
Press (SET) to go to next step.
Rated load setting
Press(SET)
FULL Press()to enter
Press () () ()to shift and select.
SET the rated load of the elevator. If the load is 2t, the parameter is SET as
2.00.
Press (SET)to auto save and go to next step.
Sensor Rated load
Press(SET)
LC
Press()to enter
Press () () () to shift and select.
SET the sensor rated load. If sensor rated load is 3t, the parameter is SET as
3.00, and two sensors SET 6.00; i.e. the total of sensors.
Press (SET) to auto save and go to next step.
Sensor sensitivity
Press(SET)
SN
Press()to enter
Press () () () to shift and select.
SET sensor sensitivity. Such as sensor sensitivity is 1.0000Mv/v, is SET to 1.000.
Press (SET) to auto save and go to next step.
Real Learning PN２
FULL
Press () () ()to shift and select.
SET the rated load of the elevator. If the load is 2t, the parameter is SET as
2.00.
Press (SET)to auto save and go to next step.
ZER0
Equipment weight all clear (including the equipment itself)
Press (SET) to auto save and move to next step.
Actual demarcation
Press(SET)
CAL Press()to enter
Press () () () to shift and select.
Weight must be lifted at the moment; enter the weight of the actual weight.
Press(SET)to auto save
Internal parameter settings Press【 】+【0】for 3 seconds
Demarcate(learning)
conversion
Press (SET) Pn 1 Press()to enter
Press () () () to shift and select.
Pn1 is no weight calibration, “the fool demarcation”.Pn2 is actual
demarcation.
Press (SET) to auto save and move to next step.
Display weight and percent
conversion
Press(SET) SP Press()to enter
Press () () () to shift and select.
PP 1 weight display mode for the "ton" or "kg"
PP 2 weight display method for%"
Calculation method for the actual weight / full scale *100% = show the
percentage weight.
Press(SET)to auto save and move to next step.
First relay SETtings Press(SET) A1 Press()to enter.
Press () () () to shift and select.
Can be set up any setting percentage output, 95% full scale output
Press(SET)to auto save and move to next step.
Press () () () to shift and select.
Can be set up any setting percentage output, 100% full scale output
Press(SET)to auto save and move to next step.
Third relay SETtings Press(SET) A3 Press()to enter.
Press () () () to shift and select.
Can be set up any setting percentage output, 105% full scale output
Press(SET)to auto save and move to next step.
For detailed parameter debugging functions, please contact us and ask for the debugging instruction book.
