Kody Technologies 101-026 User manual

Kody Technologies LLC
Bike Rack Light –RockyMounts
Kody Technologies LLC www.kodytechnologies.com
Protect Your Ride Davis CA, 95618
Congratulations on your purchase and thank you for
your commitment to road safety for your bikes,
friends, family, and those around you. Read and
follow this instruction guide to install your new Kody
Rack Light.
Disclaimer
Tail, brake and turn signal lights are a critical safety
feature during the operation of your vehicle. Rack
lights increase your vehicle’s visibility when the lights
are obstructed by a bike rack, or any other device
mounted to the rear of the vehicle. Please read and
review all information carefully before installation.
Install the light per the instructions and verify
functionality on a regular basis. If you have any
questions or concerns, please contact us at Kody
Technologies.
•Always verify cable routing and connection and
test light function prior to driving, using the light
and relying on it for your safety.
•This light adds four pounds to the load on your
bike rack. Check rack manufacturer’s manual to
verify the total load on the rack does not exceed
any limits.
•Rack lights improve your visibility and signal
communication on the road. They are not a
substitute for driving safely and following all traffic
laws.
•Kody assumes no liability for injury to persons,
damage to movable or immovable property, loss
of profit, or any other loss or damage caused by
the improper mounting or use of the carrier,
including but not limited to mounting or use in
conflict with the assembly instructions, mounting
instructions or any other instructions given, in
writing or verbally, by Kody.
Kody Technologies LLC does not assume any
responsibility or liability for accidents or injuries
resulting during use of this product or misuse of this
product.
Product Warranty
We've designed an extremely rugged rack light and
are proud to provide a 1-year warranty on any failure
on the electronics or hardware. If you experience any
issues with your light please contact us, return it and
we'll ship you a replacement.
Return Policy
If you are not 100% satisfied with the rack light, please
contact us to let us know. We offer a 30-day hassle-
free return policy. Return the light assembly in like-
new condition and we'll ship you a replacement or
refund your money. Most importantly we want to
understand any issues you experience so we can
address them, and we can continuously improve our
products.
Any questions, ideas, or concerns? Please contact us
at [e-mail]

Kody Technologies LLC
Bike Rack Light –RockyMounts
Kody Technologies LLC www.kodytechnologies.com
Protect Your Ride Davis CA, 95618
Installation Instruction
Model #: 101-026
1. The rack light bracket installs under the rear
most bike tray and frame. It uses new longer
screws, fits cleanly and does not affect any tray
left or right adjustment.
2. For Install after Rack Assembly:
Remove the four screws holding the last tray in
place.
3. Set the bracket in place on the frame aligning the
slots. Adjust bike tray to desired location. Swap
the washers from the original button head screws
to the new socket head screws.
4. Using new longer screws and washers, install the
four screws back into the rack. Tighten all four
screws while holding the rack and light in
position.
5. Route cable along the length of the bike rack and
secure with the provided cable ties. Bike racks
have many pivot points. Be sure to route the
cable away from and around pivots to keep them
from getting pinched.
6. Connect the light to your vehicle’s power supply
and test all light functions (tail, brake, hazard,
left and right-hand turn signals).
7. If lights do not function correctly on your vehicle,
please see the “How to” pages on our website
for trouble shooting or contact us.
Any questions, ideas, or concerns? Please contact us
at [email protected]
Remove Screws x4
Swap
Washers
Adjust Tray and Tighten Screws
Cable Routing