Koehlinger Kruse 1550 User manual

(260)-422-8823
OPERATING INSTRUCTIONS FOR MODEL 1550 SECURITY SYSTEM
To clear a mistake:
Press #
To arm the system when no one is staying inside the premises:
Enter the combination
The exit delay permits you to exit the delayed door. The
system senses a delayed door was opened/closed and
automatically activated the interior detection devices.
To arm the perimeter while at home and later arm the interior:
Enter the combination (activates perimeter)
Press *1 (activates interior devices)
To reset the panic system:
Enter the combination
To reset the fire alarm:
A) Before 30 seconds have elapsed - put in code to stop siren,
check to see which smoke detector went into alarm (red
light on solid) and then press *7 (hold the 7 button for
about 5 seconds) to reset the detectors.
B) After 30 seconds have elapsed - press # to stop siren,
then press *7 (hold the 7 button for about 5 seconds) to
reset detectors, then call 422-8823 to cancel the fire
dispatch.

To review an alarm event in memory (memory light on):
Press *3 (the zone or zones violated will blink
displaying any violated zones.). Press 9 previous
alarms (up to three separate alarm events will be held in
memory). Press # to return to normal. The memory light
may stay on until the system is armed the next time.
To review a trouble condition (trouble light on and system beeping every 10
seconds):
Press *2 - a zone light will illuminate indicating the type of trouble
and then the # key to return to normal.
Zone light 1 - Low battery
2 - Loss of AC power
3 - Fuse failure - bell/siren or aux. output
4 - Unsuccessful communication
5 - Fire alarm circuit trouble
6 - Loss of time on internal system clock
To arm the system when someone is staying inside the premises:
(bypassing the interior detection device)
Press *1 (zones to be bypassed - ex: 4 for zone 4, 5 for zone 5)
Press # and the combination
SILENT KNIGHT FIRE ALARM
Silence and Reset Fire Alarm
Before 30 seconds have elapsed:
• Enter 4-digit code to stop siren
• Check which motion detector went into alarm (Solid red light)
• Press *7 and hold the 7 button for 5 seconds
To reset detectors
After 30 seconds have elapsed:
• Press # to stop siren
• Press *7 and hold the 7 button for 5 seconds
• Call 260-422-8823 to cancel the fire dispatch