Kogan KATVSTHLDCA User manual

HALDEN STUDIO STAND
FOR 49"-70" TVs
(CHROME)
KATVSTHLDCA

Read the entire instruction manual before starting installation and assembly. If you have
any questions regarding any of the instructions or warnings, contact Kogan.com for
assistance.
•Closely follow the assembly instructions. Improper installation may result in
damage or serious personal injury.
•Safety gear and proper tools must be used. This product should only be installed
by professionals.
•Make sure that the supporting surface will safely support the combined weight of
the equipment and all attached hardware and components.
•Use the mounting screws provided and do not overtighten mounting screws.
•This product contains small items that could be a choking hazard if swallowed.
Keep these items away from children.
•This product is intended for indoor use only. Using this product outdoors could lead
to product failure and personal injury.
SAFETY & WARNINGS
CAUTION: Use with products heavier than the rated weights indicated
may result in instability causing possible injury.
IMPORTANT: Ensure that you have received all parts according to
the component checklist prior to installation. If any parts are missing or
faulty, contact Kogan.com.
Check that the product is secure and safe to use at regular intervals.
TOPPLING FURNITURE WARNING
• It is strongly recommended that this product is permanently fixed to the wall.
• Wall anchoring kit has been provided with this product.
• Regularly check that anchors are securely maintained.
• Stability of tall items may be affected by floor surface.
• Caution! For your safety when installing the anchor fixings, please note:
• Check any electrical wires or plumbing inside the wall before drilling any holes
(if you are unsure please seek professional advice from a qualified tradesperson).

1 x A
1 x B
2 x C
1 x D
1 x E
2 x F
1 x G
2 x H
2 x I
4 x J (M8x12)
4 x K (M6x15)
2 x L
1 x M (2mm)
1 x N (4mm)
1 x O (5mm)
4 x P
4 x Q
4 x M-A (M6x14)
4 x M-B (M8x14)
4 x M-C (M6x3)
4 x M-D (M8x30)
4 x M-E (M8x50)
4 x M-F
8 x M-G
8 x M-H
COMPONENTS

Step 1:
O
Make sure every screw is tightened before proceeding to the next step.
ASSEMBLY

Step 2:
Make sure every screw is tightened before proceeding to the next step.
VESA 400x400/600x400:50-70mm
VESA 300x300/400x300:100-170mm
VESA 200x200/300x200/400x200:90-110mm
Make sure the screw hole
turns to back
Please secure the locking
collar before attaching the
TV screen.
Tighten the screws

Step 3:
Step 4a:
Make sure the cable clips (H) are attached to the upper bracket for the following security
installation.

Step 4b:
Make sure the cable clips (H) are attached to the upper bracket for the following security
installation.

Step 5:

Step 6: