Operation Guide
1. Open the upper cover, put the item you wish to clean
into the tank, then fill it with water. (The water should
submerge the item, but not exceed the high water
mark).
Note: Running the unit without water can damage it!
2. Close the upper cover. Connect the unit to a power
source. The Power Indicator Light should turn on and
display a blue light.
3. Press ON to start cleaning the item. The Working
Indicator Light should turn on and display a red light.
Note: During cleaning, the unit may make different
sounds. These are perfectly normal.
4. After 3 minutes of cleaning, the unit will automatically
stop and the red Working Indicator Light should turn
off. If you wish to stop the cleaning earlier, press the
OFF button. If you wish to go through another
cleaning cycle with the product, simply repeat steps 3
and 4 again.
5. When cleaning is over, unplug the unit from the power
source. Then open the cover and remove the item from
the water. Pour the water out into a sink.
Cleaning Methods
There are three different cleaning methods that you can use for different situations.
General Cleaning
4
Maximum Water Mark
Simply use plain water for general cleaning.
(The water should submerge the item, but
not exceed the maximum water mark.)