Kogan C7 Series User manual

C7 CORDLESS 22.2V STICK
VACUUM CLEANER
KAVACSTC07B

To reduce the risk of fire, electric shock or injury to persons or property, the following basic
safety precautions should always be followed:
•Never use this appliance with a damaged cord, plug or other damaged parts.
Check if the voltage indicated on the label corresponds with the local mains
voltage before you connect the appliance.
•Always ensure the charging connector, cord and plug are dry. Never immerse the
appliance into the water or any other liquid. Do not rinse it under a tap except for
the dust cup, the HEPA filter and the rolling brush parts.
•Always ensure that your hands are dry before removing the plug from the mains
outlet. Never pull the plug out of the mains outlet by its cord.
•Children should always be supervised to ensure that they do not play with this
appliance.
•The appliance should not be used by adults or children who lack experience,
product knowledge or disability which might cause a hazard unless they have been
correctly instructed.
•Always keep the battery pack far from the fire and flammable items.
•Never use this appliance to suck liquids, glass, metal fragments and burning things
such as ashes, cigarette butts and matches and so on.
•Always ensure that the dust cup and the battery pack are installed before using.
•If the cord, plug and any other parts get damaged or the appliance falls into water,
stop use and immediately unplug from the main power. Never disassemble the
main body, repair or replace any parts by yourself.
Do not use any non-original parts with the unit as they may cause damage.
SAFETY & WARNINGS

•Main body •Adapter
•Floor brush •Storage base
•Battery pack •Stretch brush
•Crevice tool •User guide
•Electrical tube
1 Main unit
2 Dust cup
3 Cyclone cone
4 Battery pack
5 Electrical tube
6 Floor brush
OVERVIEW
Note:
Illustrations in this user guide are for reference only and may differ slightly.
COMPONENTS LIST

1. Insert the battery pack into the main body as picture shows. You will hear a click sound
when fitted.
2.Connect the tube to the main body.
3.Connect the floor brush to the tube.
ASSEMBLY
1
2
3
Note:
A new unit may become hot with a slight plastic odour after running the motor at high
speed for several minutes. This is normal and not a cause for concern.

Functional buttons
Speed Switch
Battery detach button
Charge set
Dust drop button
Dust cup release
ON/OFF
Floor brush unlock
Tube unlock

Press the ON/OFF button to cycle between on, high power and off.
Lithium battery charging
Attention: Use only the original charger or a replacement specified by Kogan.com;
otherwise, the lithium battery can be damaged.
The battery needs to be charged when the indicator lights blink. The indicator lights will
continue blinking while charging and turn green when fully charged.
OPERATION

Storage
Place the machine into the storage base when not in use.
Dust cup cleaning and maintenance
Method 1:
•Press the dust drop button and empty
the dust into a rubbish bin.
Method 2:
•Press the dust cup release button and
take out the dust cup from the main
body as the picture below.
•Ta k e off the HEPA filter and cyclone
cone, empty all the rubbish and clean
it. Install them back as the picture
below after the parts have air dried.
•Attention: Do not use the machine
before reinstalling the HEPA filter and
cyclone cone or it may damage the
unit.
CLEANING & CARE

Floor brush cleaning and maintenance
Step 1:
•Press the roll brush release button.
Step 2:
•Take the roll brush out.
Step 3:
•Wash the roll brush and dry it.
Install as illustrated below.
Step 4:
•Reset the roll brush release button to the lock position.

Problem Possible causes Resolutions
Not working •No power
•Brush protected or obstructed
•Charge the vacuum
•Restart the machine
Weak suction
•The dust cup is full of rubbish
•The HEPA filter is full of dust
•Floor brush or electrical tube has
been clogged by hair or large
pieces of rubbish
•Clean the dust cup’s rubbish
•Clean or change the HEPA
filter
•Clean the floor brush or
electrical tube’s inner rubbish
No LED light is
shown when
charging
•The battery pack is not installed
in the right position
•The adaptor’s connector is not
inserted in the charging hole
•Install the battery pack in the
right position
•Push the adapter's connector
into the charging hole in the
right position
Not full battery
after charging
•Charging time is not enough
•Battery is ageing
•Charge for enough time as
instructed
•Replace battery
Floor brush not
working
•Large particles or objects
vacuumed
•The resistance from the flooring
is too high and the vacuum has
entered protection mode.
•The brush roll is entangled by
hair or wire
•Clean the floor brush and
restart the machine
•Turn off the machine and take
the floor brush a little high of
the blankets leave some space
between floor brush and
blankets and restart the
machine
•Clean the brush from hair, wire
or other things
TROUBLESHOOTING

Lithium battery 2200mAh
Voltage 22.2V
Adaptor voltage ~100-240V
Adaptor output 27V 0.5A
Power 120W
Noise Approx. 68dB
Usage time Approx. 30 minutes
Charging time Approx. 4 hours
Item size 390 x 220mm
Item weight(kg) 1.44kg (Main unit)
SPECIFICATIONS