Kogan MX11 PRO User manual

MX11 PRO CORDLESS 29.6V
STICK VACUUM CLEANER
KAVACSTM11X

• Ensure to read the instructions in this user guide thoroughly before first use. Retain this
user guide for future reference.
• Use the appliance on a stable, flat, heat-resistant surface.
• Never immerse any part of the plug or the main unit in water or other liquids.
• Never leave the appliance unattended while in use.
• Ensure the power supply voltage matches the rated voltage of the appliance.
• Remove the battery pack when not in use or before performing any maintenance.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance in a
safe way by the person responsible for their safety, and understand the hazards
involved.
• This appliance is suitable for use by children 8 years and older. Pay close attention to
children’s safety when they are near the appliance. Do not let children play with the
appliance to avoid accidents.
• Do not allow pets near the appliance during operation.
• This appliance is for domestic use only. It should not be used for any purpose other than
its intended use.
• Do not use this appliance to clean up liquids, sharp objects such as nails, pushpins, etc.
• Do not disassemble or attempt to repair this appliance. Contact help.Kogan.com for
support.
• If the power cord is damaged, cease use immediately and contact help.Kogan.com
• Do not use this appliance with any accessories other than those recommended by
Kogan.com.
• In the event of a malfunction, cease use immediately and contact help.Kogan.com for
support.
SAFETY & WARNINGS

Main Unit
Aluminium Tube
Wall Bracket
Charger
Accessories
Electric Brush
2-in-1 Brush
Crevice Tool
COMPONENTS

1
Display
7
Brush Lock
2
Dust Cup Lock
8
Electric Brush
3
Dust Cup
9
Charging Indicator
4
Dust Release Button
10
Battery Pack Lock
5
Tu b e Lock
11
Battery Pack
6
Aluminium Tu b e
12
Power Switch
OVERVIEW
2
3
4
5
6
7
8
9
10
11
12
1

Display
Battery Level Indicator
Brush Blockage Indicator
Air-Duct Blockage Indicator
Dust Sensor Failure Indicator
Eco Speed
High Speed
Automatic Mode

1. Choose an accessory according to your cleaning requirement.
2. Insert the aluminium tube into the main unit until it clicks into place.
3. Insert the accessory you have chosen into the aluminium tube.
4. Make sure the installation is firm before you use it.
5. To r e m ov e t h e a l u m i n i u m t u b e , p r e s s a n d h o l d t h e t u b e lock. To r e m o ve t h e
accessory, press and hold the brush lock.
1. Press the Power switch, the appliance will turn on in eco speed mode.
2. Press the Speed Control button to place the appliance into high-speed mode.
3. Press the Speed Control button again to return to eco speed mode.
4. Press the Auto button to switch to automatic dust suction mode.
ASSEMBLY
OPERATION
Notes:
• Do not exceed the maximum line indicator in the dust cup.
• This appliance is for dry suction only.
• Ensure there is no clogging in any of the openings to avoid motor overheating and
damage.
•

Battery Pack
1. Insert the battery pack into the bottom of the main unit following the guide slot.
Ensure the battery pack is securely in place before operation.
2. To r e m ov e t h e b a t t e r y p a c k , p ress the battery pack lock and pull it away from the
main unit.
Charging
1. Connect the charger to the battery pack and turn on the power supply to start
charging.
2. When charging, the charging indicator flashes ‘BLUE’ gradually and becomes solid
when it is fully charged.
WARNING: To avoid damage, ensure the battery is charged only using
the charger supplied with this appliance.

• Never immerse the main unit in water or any other liquid.
• Only use a soft, slightly damp cloth to clean the main unit. Do not allow any liquids to
enter the main unit.
• With exception to the main unit, other parts can be washed with warm soapy water.
After cleaning, ensure all parts are thoroughly dried before reassembly and operation.
• Do not use any corrosive or abrasives chemicals.
• If the filter is damaged or worn, cease usage and replace the filter.
Cleaning Dust Cup
1. Empty the dust cup and clean the filter after every time the vacuum is used.
2. Press and hold the dust cup lock to separate the dust cup.
3. Press and hold the dust release button to empty the dust cup.
CLEANING & CARE

Cleaning Filter
1. Separate the dust cup from the main unit.
2. Remove the air inlet filter and wash it in warm water.
3. Dry the filter for 24 hours before placing it back into the dust cup.
Notes:
• Do not dry the filter using any drying equipment. Allow it to air dry naturally.
• Do not clean the filter with any cleaning equipment. Follow the instructions in this
section.
• Replace the filter every three months (depending on the usage) to ensure the
best performance.

Problem
Cause
Possible Solution
Weak suction
power
Dust cup and filters are full of
dust.
Clean the dust cup and filters
regularly.
The brush head is clogged.
Remove any hair and clean the
brush.
Abnormal sounds
The aluminium tube is blocked.
Clear the blockage inside of the
aluminium tube. If there are any
abnormalities, contact
help.Kogan.com
Charging
indicator flashes
The brush or dust cup is blocked
and has caused the current
increase.
Clean the blockage. Refer to the
“Cleaning & Care” section in this
user guide.
Ambient temperature is too
high or too low, causing the
battery humidity to be too high
or too low.
Ensure the appliance is operated
within the temperature range (0 -
55 ° C).
A different charger is being used
to charge the battery.
Charge the battery using the
charger supplied with the
appliance.
Brush is not
working
The brush head is clogged.
Remove any hair and clean the
brush.
Appliance is Not
working
The battery power is low.
Charge the battery. Refer to the
“Operation” section of this user
guide.
The aluminium tube nozzle is
blocked.
Clear the aluminium tube nozzle.
Automatic mode
failure
The aluminium tube nozzle is
blocked.
Clear the aluminium tube nozzle.
TROUBLESHOOTING

Battery Configuration
Lithium-ion 2500mAh 29.6V
Rated Power
300W
Input Power
AC 100-240V, 50/60Hz 0.5A
Output Power
DC 35V, 0.5A
Charging Time
5-6 Hours
Operating Time
Maximum of 60 minutes (when the battery is fully
charged)
Protection Class
II
Disposal
This marking indicates that this appliance should not be disposed with
other house-hold wastes. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle it responsibly to
promote the sustainable reuse of material resources.
SPECIFICATIONS

NOTES

Need more information?
We hope that this user guide has given you
the assistance needed for a simple set-up.
For the most up-to-date guide for your product,
as well as any additional assistance you may require,
head online to help.kogan.com