Kogan KAVACSTM08X User manual

MX8 CORDLESS 22.2V STICK
VACUUM CLEANER
KAVACSTM08X

•Ensure to read the instructions in this user guide thoroughly. Store the user guide
for future use.
•Use the appliance on a stable, flat, heat-resistant surface.
•Never immerse any part of the plug or the main unit in water or other liquids.
•Never leave the appliance unattended while in use.
•Ensure the power supply voltage is as per the rated voltage.
•Remove the battery pack when not in use or for maintenance.
•This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance in a safe way by the person responsible for their safety, and understand
the hazards involved.
•This appliance is suitable for children 8 years and older. Pay close attention to
children’s safety when they are near the appliance. Do not let children play with
the appliance to avoid accidents.
•Do no let the pets go near the appliance.
•This appliance is for domestic use only. It should not be used for any purpose other
than its intended use.
•Do not use this appliance to suck liquid, sharp objects such as nails, pushpins, etc.
•Do not disassemble or repair this appliance. Contact Kogan.com or the
Kogan.com recommended professionals to repair the appliance.
•If the power cord is damaged, cease use immediately and contact Kogan.com
•Use this appliance with the Kogan.com recommended accessories.
•In the event of a malfunction, cease use immediately and contact Kogan.com
SAFETY & WARNINGS

Main Unit
Aluminium Tube
Wall Bracket
Charger
Accessories
Electric Brush
2-in 1 Brush
Crevice Tool
COMPONENTS

1
Primary Screen
8
Brush Lock
2
Compact Screen
9
Electric Brush
3
Dust Cup Lock
10
Charging Indicator
4
Dust Cup
11
Battery Pack Lock
5
Dust Release Button
12
Battery Pack
6
Tube Lock
13
On/Off Switch
7
Aluminium Tube
1
2
3
4
5
6
7
8
9
10
11
12
13
OVERVIEW

Compact Screen
Battery Level Indicator
Eco Speed
High Speed
Automatic Mode
Speed Control Button

1. Choose an accessory according to your cleaning requirement.
2. Insert the aluminium tube into the main unit until it clicks into the place.
3. Insert the accessory you have chosen into the aluminium tube.
4. Make sure the installation is firm before you use it.
5. To remove the aluminium tube, press and hold the tube lock. To remove the
accessory, press and hold the brush lock.
1. Press the on/off switch, the appliance will start to work in the eco speed mode.
2. Press the speed control button, the appliance will work in the high speed mode.
3. Press the speed control button again to return to the eco speed mode.
4. Press AUTO to switch the automatic dust suction mode.
ASSEMBLY
OPERATION
Note:
•When using, do not exceed the maximum line indicator in the dust cup.
•This appliance is for dry suction only.
•Ensure there is no clogging in any of the openings to avoid motor
overheating and damage.

Battery Pack
1. Insert the battery pack into the place along the guide slot and ensure the battery
pack is fixed firmly.
2. To remove the battery pack, press the battery pack lock.
Charging
1. Connect the charger to the battery pack and turn on the power supply to start
charging.
2. When charging, the charging indicator flashes blue light gradually and becomes
solid when it is fully charged.
WARNING: Charge the battery with the charger supplied with the appliance to
avoid damage.

•Never immerse the main unit in water or any liquid.
•Only use a soft, slightly damp cloth to clean the main unit. Do not allow any liquid
substances to enter the main unit.
•Except the main unit, other parts can be washed with warm soapy water. After
cleaning, it must be thoroughly dried.
•Do not use any corrosive chemicals or abrasives.
•Do not use when the filter is damaged or worn.
Cleaning Dust Cup
1. Empty the dust cup and clean the filter every time it is used.
2. Press and hold the dust cup lock to separate the dust cup.
3. Press and hold the dust release button to empty the dust in the dust cup.
CLEANING & CARE

Cleaning Filter
1. Separate dust cup from the main unit.
2. Remove the air inlet filter and wash it in warm water.
3. Dry the filter for 24 hours before placing it back into the dust cup.
Note:
•Do not dry the filter with drying equipment. Dry naturally.
•Do not clean it with other cleaning equipment. Follow the instructions in
this section.
•Replace the filter every three months (depending on the usage) to ensure
the best performance.