Kohl's Cameron User manual

1
PART LIST QUANTITY
A2 PCS
B4 PCS
C4 PCS
D4 PCS
E4 PCS
F8 PCS + 1 PC
G8 PCS + 1 PC
H8 PCS + 1 PC
I16 PCS + 1 PC
J1 PC
FOR MISSING OR INCORRECT PARTS/HARDWARE, CONTACT THE MANUFACTURER'S CUSTOMER SERVICE DIRECTLY AT
1-847-608-5202 OR [email protected]
REFER TO LAST PAGE FOR ADDITIONAL CUSTOMER SERVICE DETAILS.
1/4" x 2-1/4" BOLT
SAVE THESE INSTRUCTIONS
SET OF 2 CAMERON COUNTER STOOLS ASSEMBLY INSTRUCTIONS
ASSEMBLE ON A FLAT, PROTECTED SURFACE
FIGURE
DESCRIPTION
SEAT
LEFT LEG
PHILLIPS HEAD SCREWDRIVER NEEDED FOR ASSEMBLY; NOT INCLUDED
RIGHT LEG
FLAT WASHER
LONG STRETCHER
SHORT STRETCHER
SPRING WASHER
5/16" X 1-1/2" WOOD SCREW
ALLEN WRENCH

2
STEP 1
A. PLACE SEAT (A) UPSIDE DOWN ON A FLAT,
PROTECTED SURFACE.
B. ATTACH LEFT LEGS (B) AND RIGHT LEGS (C) TO
SEAT (A) AS SHOWN WITH BOLTS (H), SPRING
WASHERS (F) AND FLAT WASHERS (G).
C. LOOSELY TIGHTEN USING ALLEN WRENCH (J).
STEP 2
A. INSERT LONG STRETCHERS (D) INTO LEFT LEGS (B)
AND RIGHT LEGS (C) AS SHOWN.
B. INSERT SHORT STRETCHERS (E) INTO LEFT LEGS
(B) AND RIGHT LEGS (C) AS SHOWN.
STEP 3
A. ATTACH ALL THE STRETCHERS TO LEFT LEGS (B) &
RIGHT LEGS (C) USING WOOD SCREWS (I).
B. FULLY TIGHTEN ALL SCREWS (I) WITH A PHILLIPS
HEAD SCREWDRIVER (NOT INCLUDED).
ASSEMBLY INSTRUCTIONS (CONTINUED)

3
WEIGHT LIMIT:
TOP: 300 LBS
CARE AND CLEANING
WIPE CLEAN WITH A SOFT, DRY CLOTH AS NEEDED.
DO NOT SIT, STAND, OR CLIMB ON THE STOOL
INTENDED FOR INDOOR USE ONLY.
FOR MISSING OR INCORRECT PARTS/HARDWARE, CONTACT THE MANUFACTURER'S CUSTOMER SERVICE DIRECTLY AT
1-847-608-5202 OR [email protected]OM
STEP 4
A. ROTATE ASSEMBLED UNIT TO UPRIGHT POSITION.
B. CHECK AND MAKE SURE ALL LEGS TOUCH THE
FLOOR.
C. FULLY TIGHTEN ALL BOLTS USING ALLEN WRENCH
(J).
D. REPEAT ALL STEPS FOR SECOND STOOL
ASSEMBLY.
** WE RECOMMEND THAT YOU SAVE THE ALLEN WRENCH AND PERIODICALLY TIGHTEN ALL BOLTS.
ASSEMBLY INSTRUCTIONS (CONTINUED)