Kollercraft Betta Bowl Aquarium Setup guide

SAVE THESE INSTRUCTIONS
061014DM
How to set up your new Betta Bowl Aquarium
Setting up your new aquarium is not difficult. An aquarium is a beautiful, fascinating addition to your home, dorm or
office and can become a welcome source of enjoyment, education, and relaxation.
Pick a location away from direct sunlight, heat, or air conditioning. Direct sunlight can cause unwanted algae growth
that can cover your rocks and decorations. Placement of the aquarium away from heating and air conditioning vents is
also important, because it is easier to maintain proper aquarium temperature when the surrounding air temperature is
relatively stable. Place the aquarium where you will be able to see and appreciate the beauty of your fish.
1. Rinse your tank with warm water only. Do not use soap, detergents or cleaning agents. These cleansers may leave
residues that can be harmful to your fish. Avoid using any used rags or sponges that were used for cleaning and
contain harmful chemicals; these can be toxic to your fish also. Wipe the water off the outside of the tank with a
clean, soft cloth.
2. Place your aquarium on a level surface because an aquarium filled with water, gravel, rocks, and decorations will
weigh about 10 lbs. per gallon.
3. Rinse your aquarium gravel and decorations (not included) thoroughly. Empty the bag of gravel into a new plastic
bucket or one that has never been used with chemicals. Place the bucket in the sink and turn the cold water on,
allowing the tap water to fill the bucket. Gently stir the gravel as the water fills the bucket and continue to do so as
the bucket overflows, rinsing the gravel until the water runs clear. Place gravel, rocks and decorations in the tank
now, spreading the gravel evenly across the bottom of the aquarium.
4. Fill aquarium with water to within two to three inches of the top of the aquarium and Water Conditioner to remove tap
water chemicals such as chlorine and chloramine.
5. Depending on the type of light your kit includes you can change the batteries (not included) as shown below. Light
Hood must always be in place during operation. Replace batteries as necessary. When the LED light ceases to
work, visit your retailer to purchase replacement.
GETTING STARTED
This model takes 2 AA
Batteries (not included) , use
screwdriver to remove cover.
Part #ISZ-GBK-GN
Warning:
Do not mix old and new batteries
Do not mix Alkaline, Standard or rechargeable batteries

IF ANY COMPONENTS ARE
DAMAGED OR MISSING DO NOT
RETURN TO THE STORE
CALL (800)-545-1344
OR GO TO www.kollercraftproducts.com
Email [e-mail]
6. Allow your aquarium to operate for at least 24 hours before adding fish.
7. Be sure that the fish you select are compatible with each other. Only add one fish at the beginning. After two weeks you can add another fish.
A good guide to follow is one inch of fish per gallon of aquarium.
8. It will take 4 to 6 weeks for the aquarium to cycle and establish a favorable balance. During this time it is important not to add too many fish or
your aquarium may become cloudy and you may possibly lose fish.
9. Monitor the ammonia, nitrite and pH levels weekly. If the ammonia or nitrite levels become too high or the pH level too low perform a partial
water change. Your aquarium’s ammonia and nitrite levels should be at recommended levels.
10. DO NOT LIFT OR MOVE YOUR AQUARIUM WHEN FILLED WITH WATER. Damaged to your aquarium may occur.
11. Aquarium water temperature. A constant water temperature between 70 °F to 80 °F is acceptable for most tropical fish and will aid in main-
taining a healthy environment. Most of the time ambient room temperature will keep your aquarium at a constant temperature. If you find
the aquarium temperature is fluctuating then adding an aquarium heater is recommended.
12. Your aquarium comes with energy efficient LED lighting with switchable colors. LED colors can be easily switched from one color to another
by pressing the On/Off button. The LED light is factory preset to turn off after 2 hours to extend battery life.
SELECTING FISH
Patience is important when establishing your new aquarium. Begin by talking to an aquatic professional about which fish are best suited for your
aquarium and are compatible with each other, and how many would be appropriate for your aquarium. Inform them that you have just set up a
new aquarium so they can recommend hardy fish. Be sure that the fish are eating and acting normally. Check for ragged fins that can be
caused by harmful bacteria or white spots caused by parasites. Always choose healthy looking fish.
1. Bring your fish home directly from the store; you do not want them to be in the bag any longer than necessary.
2. Add only a one fish. Remember to choose only fish that are active and healthy. Take special care not to overcrowd your aquarium. Few-
er, healthier fish are better than an overcrowded, stressed population.
INTRODUCTION OF YOUR FISH
1. Float the bag with your new fish on the surface of the aquarium for 15 minutes.
2. Open the bag containing your new fish, taking care that the bag does not collapse, and add a little aquarium water every two minutes.
3. Continue this process for 10 minutes, allowing the bag to fill with water.
4. Take bag with fish to sink and gently scoop fish out with a net or pour bag of water into net. Now gently place fish into aquarium. Do not
add water from fish bag in order to prevent introduction of possible disease or parasites from store water.
5. It is recommended to keep your aquarium lights off for twenty-four hours. A dark aquarium is less stressful to your fish. Be sure to offer
your new fish hiding places, as this also helps alleviate stress. Do not add too many fish, remember not to overcrowd.
TAKING CARE OF YOUR FISH
1. Refer to a pet care guide for information about caring for your specific type of fish.
NEVER USE WINDOW CLEANER, ABRASIVE CLEANERS, HOUSEHOLD CLEANERS, SCOURING
COMPOUNDS, GRITTY CLOTH, OR STRONG SOLVENTS SUCH AS ALCOHOL, ACETONE, OR CAR-
BON TETRACHLORIDE. THIS WILL CAUSE DAMAGE TO THE AQUARIUM’S SURFACE.