Komos RUBICON DRAFT BOX User manual

1
INSTRUCTION MANUAL
RUBICON
DRAFT BOX
Thank you for your purchase of the KOMOS
Rubicon Draft Box. You are going to love
serving beverages using the Slimline
cast aluminum cold plate, which provides
better heat absorption than stainless steel
coils, and is compact enough to leave plenty
of room in the cooler for other food or
beverages.
Assembly Instructions
• 1 x KOMOS Slimline Cold Plate
• 2 x Intertap Faucets
• 2 x Faucet Handles
• 2 x Self Closing Faucet Springs
• 2 x Dra Shanks with Duotight Tailpiece
• 4 x Duotight Fittings with 1/4" Flare Thread
• 4 x Duotight Elbow Fittings
• 1 x Roll of 5 mm ID x 8 mm OD EVABarrier Dra Line
• 1 x Tubing Cutter
• 1 x Dra Wrench
Before you begin to assemble the Dra Box, rst unpack and take stock of all the
included parts. Make sure you have the following items:
What's Included:
TIP - we suggest using a ruler or tape measure to cut the dra lines to our recommended
lengths, although it isn’t required if you prefer to measure out and cut the lines as you go.

2
Once you have all of the parts in front of you, we’re ready to assemble the dra
box.
Assembly:
1. Place the Slimline cold plate inside the cooler with the beverage inlet/outlets facing the
right side where the pre-drilled holes are located.
2. Assemble the faucets and shanks. The self-closing spring should be placed in between the
faucet and shank, with the wider end of the spring inserted into the shank. Use the dra
wrench to tighten the faucet collar onto the shank.
3. Remove the Duotight tting and hex nut from each shank, then install the shanks in the
pre-drilled holes at the front of the cooler. Thread on the hex nut and tighten in place.
Attach the Duotight ttings with Female Beer Thread on the back of the shanks.
4. Attach the (4) Duotight ttings with Female Flare Thread to the beverage inlets and
outlets on the cold plate.
5. Cut (6) lengths of dra line in the following lengths:
• 1 x 20" length
• 1 x 9" length
• 2 x 6" lengths
• 2 x 3" lengths
6. To attach the dra line to the Duotight ttings, push the tubing rmly into the tting and
pull back slightly to lock in place.
7. Attach the 20" line to the le hand side shank and then to either outlet located on the
right hand side of the cold plate.
8. Attach the 9" line to the right hand side shank and then to the remaining outlet located
on the right hand side of the cold plate.
9. Attach one Duotight Elbow to each of the 6" lines and then attach them to the cold plate
inlets on the le side of the cold plate.
10. Attach a 3" line to each Duotight elbow and feed it through the pre-drilled holes, then
attach the remaining Duotight elbows to the line on the outside of the cooler.
11. The remaining EVABarrier dra line can be cut to whatever lengths best suit your needs.
If you are serving from homebrew kegs, you may also need 4 additional Duotight ttings
with Female Flare Thread. If you are serving from commercial kegs, you may also need 4
additional Duotight ttings with Female Beer Thread.