Kramer OWB-1G User manual

KRAMER
OWB-1G Quick Start
This guide helps you install and use your product for the first time. For more detailed information, g
http://www.kramerav.com/manual/ or scan the QR code on the left.
o to
On-Wall Box (EU)
Step 1: Check what’s in the box
1 gang metal frame for two inserts Wall mounting kit
The OWB-1G On-wall Box
Step 2: Overview
Installing the Inserts
To install the inserts onto the OWB-1G, do the following:
Connect the cable ports to the rear side of the insert(s).
3. Use 2 screws to attach the metal insert frame to the
OWB-1G.
1. Mount the inserts onto the supplied metal frame (inserts are not included and can be purchased separately).
2.
Step 3: Installing the OWB-1G
OWB-1G Quick Start (P/N: 2900-300078QS REV 2)
2 9 0 0 - 3 0 0 0 7 8 QS
2
To mount the OWB-1G to a wall or other surface, do the following:
If you want to feed the cables to the OWB-1G from any of the four sides, carefully break the knock-off holes where appropriate
(knock-off holes are shown as gray dotted lines in the illustrations below).
Feed the cables from the rear/sides of the OWB-1G out through the front.
Hold the OWB-1G in position against the wall or surface on which it is to be mounted, taking care that the OWB-1G is level, and
attach it using the wall mounting kit.
You can install either two inserts or a 1 gang European wall plate.
The OWB-1G is a white plastic wall-box for mounting two Kramer inserts or a 1 gang European wall plate. The box is mounted on the
wall for applications where in-wall installation is not possible.
Rev:
P/N:

WWW.KRAMERAV.COM
To mount a wall plate onto the OWB-1G, do the following:
1. Connect the cables to the relevant connections on the wall plate.
2. Remove the screws securing the face plate of the wall plate.
3. Insert the wall plate (with the face plate) into the OWB-1G.
4. Secure the wall plate with the 2 screws to the OWB-1G.
2
Specifications