Krug ASCEND 64526 User manual

Date: 27 Jan 2020
Revision A
FOR ASSISTANCE, PLEASE CONTACT CUSTOMER SERVICE AT 1.888.578.5784 AND
YOU WILL BE DIRECTED TO THE APPROPRIATE INSTALLATION SUPPORT PERSONEL.
64526 ASCEND OPERATION INSTRUCTIONS
Instructions for Operating the Ascend Exam Recliner (ASC8)
Operating Instructions
1
Recline Controls
Located on the side of the arm, the Ascend hand
wand is used to control both the back recline and
the footrest. The top two buttons control the
back, the middle two buttons control the ottoman
and the lower two buttons control the back and
ottoman simultaneously.
1
2
3
Lift Controls
Located on the side of the arm, the Ascend lift
control is used to move the unit up and down.
Simply press on the up or down button until you
reach your desired height. Do not operate the
lift while the unit is in Trendelenburg mode.
If applicable stow the swing tablet before
use.
Patient Transfer Arm (Optional Feature)
To activate this feature pull down on the lever
located at the front of the arm. This will un-lock
the arm and allow you to swing the upper portion
of the arm down and out of the way. Once you
are done using it lift the arm back into the
upright position and pull up on the locking lever.
When the arm has been re-locked gently
wiggle it back and forth to ensure it is
secure. If the transfer arm is excessively loose
or is very hard to lock adjust the built in
adjustment screw located inside the upper
portion of the arm. Loosening the screw will
make the arm easier to open while tightening it
will make it lock more firmly.
12
3
3

Date: 27 Jan 2020
Revision A
FOR ASSISTANCE, PLEASE CONTACT CUSTOMER SERVICE AT 1.888.578.5784 AND
YOU WILL BE DIRECTED TO THE APPROPRIATE INSTALLATION SUPPORT PERSONEL.
64526 ASCEND OPERATION INSTRUCTIONS
Instructions for Operating the Ascend Exam Recliner (ASC8)
Operating Instructions
2
Trendelenburg Lever (Optional Feature)
Ensure the unit is in it’s lowest position
before operating the Trendelenburg feature.
To convert the unit into Trendelenburg mode
press down on the red foot activated pedal below
the arms. Once the pedal is pressed gently push
down on the back. Releasing the foot pedal will
engage the lock and ensure that the chair stays in
place. To get the chair back into the standard
position press down on the foot pedal again and
gently press down on the seat until it is
horizontal.
Stirrups (Optional Feature)
The stirrup bars are located just below the seat.
Using one finger, pull them out to the desired
length. Remove the stirrups from the holder on
the side of the arm and slide the stirrup onto the
stirrup bar.
Paper Roll Holder (Optional Feature)
This feature excepts an 18” wide roll of exam
paper. To load/unload rolls untighten the black
knobs found on either end of the bar. Remove the
bar, and slide it thru the roll of paper. Re-install
the bar ensuring that the thumbscrews are tight.
4
5
6
6
4
5

Date: 27 Jan 2020
Revision A
FOR ASSISTANCE, PLEASE CONTACT CUSTOMER SERVICE AT 1.888.578.5784 AND
YOU WILL BE DIRECTED TO THE APPROPRIATE INSTALLATION SUPPORT PERSONEL.
64526 ASCEND OPERATION INSTRUCTIONS
Instructions for Operating the Ascend Exam Recliner (ASC8)
Operating Instructions
3
Flip Tablet (Optional Feature)
To raise the tablet, pull up on it until it is
horizontal and “clicks” into place. To lower,
depress both safety latches located on the tablet
bracket and slowly lower the tablet into it’s resting
position.
Swing Away Tablet (Optional Feature)
To use, rotate the tablet up to a minimum of 90°
from it’s resting position and lower it in front of the
patient so it is sitting parallel to the floor. To stow
the tablet flip it up so the tablet surface is parallel
to the side of the arm and rotate it back to it’s
resting position. Care should be taken when
stowing the tablet. Do not allow it to fall
freely as this may cause damage to both the
unit and the tablet.
7
9
8
PowerDoc (Optional Feature)
Press down on the inner front edge to pop the
unit out. Once you are done using it press back
down until an audible click is heard.
7
8
9