Kumio ICM1550 User manual

ICE MAKER
INSTRUCTION MANUAL
Model: ICM1550
THANK YOU FOR CHOOSING OUR ICE MAKER
PLEASE READ THE MANUAL CAREFULLY BEFORE OPERATING

2
IMPORTANT NOTICES
When using an electrical appliance, basic safety precautions should
always be followed to reduce the risk of fire, electric shock,
and/or injury, including the following:
1. Read all instructions before using.
2. Remove all packing material and carefully check your ice maker
to ensure it is in good condition and that there is no damage to
the ice maker or power cord and plug.
3. Before using the Ice maker for the first time, please wait 2 hours
after positioning it, and keep the transparent lid open for at least
2hours
4. Pure water is not allowed to be used on this unit, spring water is
recommended.
5. Ensure the voltage is compliant with the voltage range stated on
the rating label, and ensure the earthing of the socket is in good
condition.
6. If the supply cord is damaged, it must be replaced by the
manufacturer or its service agent or a similarly qualified person in
order to avoid a hazard.
7. Do not upend this product or incline it over a 45℃angle.
8. To protect against risk of electric shock, do not pour water on
cord, plug and ventilation, immerse the appliance in water or any
other liquid.
9. Unplug the appliance after using or before cleaning.
10. Keep the appliance 8cm from other objects to ensure the good
heat releasing.
11. Do not use the accessories which are not recommended by
Manufacturer.
12. This appliance is not intended for use by persons (including

3
children) with reduced physical, sensory or mental capabilities, or
lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
13. Do not use the appliance close by flames, hot plates or stoves.
14. Do not switch on the power button frequently (ensure 5min.
interval at least) to avoid the damage of compressor.
15. Metal sheet or other electric objects are not allowed to be
inserted into the appliance to avoid fire and short circuit.
16. Do not use outdoors.
17. Never clean with scouring powders or hard implements.
18. Please keep the instruction manual.
19. Warning: Do not store explosive substances such as aerosol
cans with a flammable propellant in this appliance.
20. This appliance is intended to be used in household and similar
applications such as
– staff kitchen areas in shops, offices and other working
environments;
– farm houses and by clients in hotels, motels and other
residential type environments;
– bed and breakfast type environments;
– catering and similar non-retail applications
21. When positioning the appliance, ensure the supply cord is not
trapped or damaged.
22. Do not locate multiple portable socket-outlets or portable power
supplies at the rear of the appliance

4
This symbol indicates the refrigerant R600a and the
non-metallic materials of the appliance are flammable. It’s a warning
symbol. Warning: Risk of fire / flammable materials.
WARNING: When positioning the appliance, ensure the supply cord
is not trapped or damaged.
WARNING: Do not locate multiple portable socket-outlets or portable
power supplies at the rear of the appliance.
Children aged from 3 to 8 years are allowed to load and unload
refrigerating appliances. To avoid contamination of food, please
respect the following instructions:
–Opening the door for long periods can cause a significant increase
of the temperature in the compartments of the appliance.
–Clean regularly surfaces that can come in contact with food and
accessible drainage systems.
–Clean water tanks if they have not been used for 48 h; flush the
water system connected to a water supply if water has not been
drawn for 5 days.
–If the refrigerating appliance is left empty for long periods, switch
off, defrost, clean, dry, and leave the door open to prevent mould
developing within the appliance.)

5
SPECIFICATIONS
Model Number: ICM1550
Voltage: 120V/60Hz
Power Consumption: 150 W
Daily Ice Output: 15kg / 24 hours
Ice Storage Capacity: 1.8L/700 g
Water Reservoir Capacity：2.3 L
N.W:
G.W :
Ice Making Mode: big and small
Compression-type Refrigeration: 120V/60Hz
Cooling Agent: R600a environmental friendly refrigerant
Max overall dimensions(W XD XH): 344 x 296 x 372 mm
Packing Dimensions(L XW XH): 350 x 340 x 425 mm

6
DESCRIPTION
CONTROL PANEL INDICATOR LAMP
BUTTONS
TOP LID
REAR HOUSNG
ICE BASKET
AIR VENT
WATER TANK
FRONT HOUSING

7
FEATURE
Quick ice making
Two different sizes of ice can be made
Prompt when the ice is full and water is insufficient
Bullet ice
10 pcs ice can be made in 8-9 minutes.
1. During transportation, do not tilt the machine more than 45
degrees, do not reverse the machine. This may damage the
compressor and the sealing system.
2. Remove all packing materials, check the machine carefully and
make sure that the machine, power cord and plug are normal.
3. The machine should be on a level surface. To ensure sufficient
ventilation, the distance of the back of ice maker to the wall should
be at least 150 mm, it should be away from the oven, radiator or
other heat source.
4. Before using the machine for the first time, place the machine and
keep the ice basket removed for at least two hours.
5. Make sure that the home voltage is consistent with the voltage
indicated by the machine.
6. Distilled water is not allowed. Mineral water is recommended. The
transparency of ice making with pure water is higher than that with
tap water.
7. Under different temperature conditions, the transparency of ice
made with different water is different. The transparency of ice is
higher in higher temperature environment, and the transparency of
ice will decrease with the increase of ice making time.

8
CONTROL PANEL OPERATION
POWER：Power Supply SELECT：Mode selection
S: small ice selection L: big ice selection
ICE FULL: water full alarm ADD WATER: water shortage alarm
1. Plug in the power supply and the “L” indicator flashes. Press the
“POWER” button, the “L” indicator light is always on, the
machine will start the deicing function first, then automatically
make the ice according to the selected mode, deicing after the
completion of ice making, and then enter the deicing function,
such a cycle.
2. SELECT: select the ice size mode, and the default mode is large
ice making mode for each startup. Select the mode: “S” for small
ice selection, “L” for large ice selection and the corresponding
indicator light is on. The production time of small ice is more than
8 minutes and that of large ice is more than 9 minutes.
3. ADD WATER: water shortage alarm: when the light is red, it

9
means water shortage in the water tank. You need to add water
and press the “POWER” button to restart the machine.
4. ICE FULL: ice full alarm. When the ice reaches the maximum
amount of ice storage container, the "ICE FULL" light flashes
and the machine stops. At this time, the ice needs to be poured
out. When the ice position is lower than the full sensor position,
the machine will restart automatically.
5. CLEAN:Press the “POWER” button for 3 seconds, and the
machine will enter the self-cleaning mode. The water pump will
pump water and the water box will pour water. After 5 cycles, the
machine will stop and enter the standby mode.
OPERATION INSTRUCTIONS
Step 1
Take out the ice basket and add water to the water tank.
Note: There is a maximum scale MAX in the reservoir. The water
should not exceed the MAX position. If the water exceeds the
maximum scale MAX, you need to open the bottom drain plug,
release the excess water, and reinstall the water tank.
Step 2
Plug in the power and press the “POWER” button to start the
machine.
Step 3
Select the size of the ice you want to make, the default mode is large
ice.

10
1. When the indoor temperature is lower than 20 degrees, please
choose small ice. When the indoor temperature is higher than 30
degrees, it is recommended to choose large ice.
2. The three cycles used for the first time, the ice produced is small
and irregular.
3. When the ice basket is full, please take out the ice immediately.
The ice will melt if the time is too long.
CLEANING & USE GUIDANCE
1. Clean the ice basket and water tank frequently. W hen cleaning,
unplug the unit and remove the ice cubes. Use a diluted solution
of water and vinegar to clean the inside and the outside surface
of the Ice maker. Do not spray Ice maker with chemicals or
diluted agents such as acids, gasoline or oil. Rinse thoroughly
before starting.
2. Keep ventilation openings in the appliance enclosure, or in the
built-in structure, clear of obstruction. Do not use mechanical
devices or other means to accelerate the defrosting process,
other than those recommended by the manufacturer.
3. Reuse the machine after being idled for a period of time, it may
not have enough water to pump for air retard, in this case, the
water shortage indicator "ADD WATER" will be on. Repress
“POWER” button to restart the ice maker is okay.
4. To ensure the cleanness of ice, please change water for water
reservoir at least once one day. If do not use for a long time,

11
please drain the water out and clean it up.
5. If the compressor takes a strike action for shortage water, fully
water or interruption of power supply, it will delay for 3mins to
start up after restarted.
6. When the machine is used again after a long time, please start
the cleaning function first. Purified water is recommended.

12
TROUBLE SHOOTING
PROBLEM POSSIBLE CAUSE SUGGESTED SOLUTIONS
The compressor works
abnormally with a
buzzing noise
The voltage is lower than
recommended
Stop the Ice maker and do not restart
until the voltage is normal.
Water shortage
indicator light is on
1.There is no water
2.The pump is full of air
1.Add to some water until it reaches
MAX position
2.Press POWER button to restart
Indicator lights on
display are not on Blown fuse/ No power Replace fuse / Turn power on
The Ice made is too
large and with pieces
sticking together.
1. Wrong ice size selected
2.Ice of previous cycles left
in the water tray
1.Select small size
2. Unplug the power and plug it in
again.
The ice making process
was correct, but no ice
came out?
1. The compressor has
no refrigerant
2. Compressor damaged
3. Fan motor damaged
Call the service hotline
All indicators flash at
the same time.
1. The water box is blocked
by ice.
2.
The motor is stuck, or
the motor falls off, or the
motor is damaged
3. Micro switch damaged
1. Unplug the power and plug in the
power again, and press the POWER
button. After 3 minutes, the machine
will restart automatically.
2. Call the service hotline

13
The machine has been
working, but the water
has been warming
Solenoid valve failure Replace the solenoid valve
When the ice is full, the
machine does not
display the ice full Icon
Ice full sensor damaged
Solar light interference
1. Replace the ice full sensor
2. Call the service hotline
The ice is not clear at all
1. Water supply pump
does not work
2. Tap water was used
1. Call the service hotline to replace
the water pump
2. Use purified water
1. If the power cord is damaged; it must be replaced by the
manufacturer, its service agent or a similarly qualified person in
order to avoid a hazard.
2. Fill with potable water only.
3. It is normal for the compressor and condenser surface to reach
temperatures between 70°C and 90°C during operation and
surrounding areas may be very hot.
4. Due to fast freezing, ice cubes may opaque. This is air trapped in
the water and will not affect quality or taste of ice.
5. This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities or
lack of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance by a
person responsible for their safety.

14
6. Children should be supervised to ensure that they do not play
with the appliance.
7. Do not immerse in water.
Correct Disposal of this product
This marking indicates that this product should not
be disposed with other household wastes throughout
the EU. To prevent possible harm to the environment
or human health from uncontrolled waste disposal,
recycle it responsibly to promote the sustainable
reuse of material resources. To return your used
device, please use the return and collection systems
or contact the retailer where the product was
purchased. They can take this product for
environmental safe recycling.

WARRANTY
Limited two-year warranty
This warranty is available to consumers only. You are a
consumer if you own a kumio ice maker that was purchased at
retail for personal, family or household use. Except as
otherwise required under applicable law, this warranty is not
available to retailers or other commercial purchasers or owners.
We warrant that your kumio ice maker will be free of defects in
materials and workmanship under normal home use for 2 years
from the date of original purchase. If your kumio ice maker is
prove to be defective (Non Man-damaged)within the warranty
period, we will offer free replacement or reimburse.
Thank you for using our products. Please contact
[email protected] or Customer Service Online if you have any
questions.