___________________________________________________________________________________________
2EB-9V
SECTION 1 : FEATURES
●No external battery or DC power supply required, excitation power provided by an internal battery.
●Small size, light weight and easy installation saving labor.
●Automatic excitation detection requires no manual operation or settings.
●Very low static power consumption, Up to 3 years between battery replacement in standby mode.
●Excitation function repeats 3 times and stops automatically when voltage is established.
●Battery low voltage indicator reminds user to change battery.
●Up to three repeat flashing attempts and will automatically stop when voltage builds up.
●Excitation failure indicator. Resets automatically when voltage builds up or engine is stopped.
●Battery reverse polarity protection.
●Excitation field F+, F- Reverse Polarity Protection.
●Built in manual forced excitation push button.
SECTION 2 : SPECIFICATION
Lithium Battery Specifications
Voltage 1 300 Vac 1 phase 2 wire
Model no. Ultralife U9VL-J-P
Current Normal discharge 700 mA Max
Pulse discharge 1050 mA Max
Capacity 1200 mAh @ 23 ˚C
Flashing Output Conditions
When voltage less than 10 Vac at frequency greater
Operating Temperature -20 to +60 ˚C
Storage Temperature -40 to +60 ˚C
Relative Humidity Max. 95%
Excitation output 5 seconds. Up to 3 attempts at 5
87.0 (L) x 41.5 (W) x 61.7 (H) mm
Time Between Battery Change
3.42 (L) x 1.63 (W) x 2.43 (H) inch
( Use only Ultralife U9VL-J-P lithium battery )
ATTENTION
1. Before using a Megger remove all wires connected to the EB-9V to prevent high voltage damage to the
unit.
2. Only an ULTRALIFE U9VL-J-P lithium battery should be used for replacement.
3. Use of other battery models will reduce the time the unit can operate and the service life of the battery
and could lead to failure of voltage build-up.
