Kvarta DVB MONITOR M1 User manual

www.kvarta.net
DVB Monitor M1 Quick Start Guide
DVB Monitor M1
Quick Start
1. Unpacking
Check that all these accessories are present:
1 power supply cable
1 straight ethernet cable
1 quick start notice
2. Connecting to the embedded Web site
1. Connect the Ethernet cable between the RJ45 and the network..
2. Input A is for DVB-S/S2; Input B for DVB-C/T/T2/Analogue
3. Default IP: 192.168.2.3 (admin/admin)
NOTE: Your computer should be in the same network.
4. Open a Web browser (Internet
Explorer, Mozilla…) and enter the
device IP address. Login with the
default username and password (admin/admin). The
home page of the embedded web site is displayed:
3. Configuring the DVB settings
•On the embedded web site home page, click “Config > Configuration”:
•Set the mode Scanning/Monitoring mode, tuner mode and frequency
a. For streaming, STREAMING should be ON
b. For monitoring, and alarms MONITORING should be ON
•In the “Config > General” tab set various settings for the reception
•Click the “Save” button to lock in your changes.

www.kvarta.net
DVB Monitor M1 Quick Start Guide
4. Look at current DVB status for RF parameters
•On the embedded web site go to “Status > Status”. If everything is OK the Demodulator
should be locked as in the picture below
5. Configure the IP Stream
•On the embedded web site go to “Config > Stream”
•Select the Stream protocol
•Select the Service
•Select the destination address
Please check the user manual for more information on how to communicate with your
device and how to configure it.