KWIK GOAL WC-240 User manual

ASSEMBLY INSTRUCTIONS FOR WC-240 & WC-240AS TRAINING FRAMENXT
1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify trucking company immediately. Lay out all parts. Remove all cardboard and packaging immediately.
Wet or damp packaging may damage contents.
2. Read through entire instruction before beginning assembly and installation.
NOTE: Components may be packaged in one or more additional boxes.
140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
2016 Kwik Goal Ltd.
NZ409 Rev. 12/01/16
Crossbar Corner (2)
(Part# UZ1554)
92° Mark
Net (1)
(Part# WC-24GAW)
Pilot Hole Peg (1)
(Part# UZ847)
Net Fastener (6’)
(Part# MNF-1 Roll of 12’)
Carry Bag (1)
(Part# 5B406)
Crossbar (1)
(Part# WZ1003)
97-5/16”
Crossbar w/ Swage (2)
(Part# UZ1549)
97-5/16”
89-7/8”
Post (2)
(Part# UZ1557)
Plastic Cable Tie (4)
(Part# JZ225 Pack of 4)
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.

140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
1998 rev 2009 Kwik Goal Ltd.
IMPORTANT GOAL SAFETY INSTRUCTIONS
READ CAREFULLY
1. Check for structural integrity and proper connecting hardware before every
use. Replace damaged or missing parts or fasteners immediately.
2. Safety/Warning labels must be clearly visible.
3. Securely anchor moveable soccer goals at ALL times.
4. Always instruct players, managers, coaches, trainers, teachers, maintenance
workers and all other personnel who might come in contact with the goal,
on the safe handling of and potential dangers associated with moveable
soccer goals.
5. Always exercise extreme caution when moving goals and provide adequate
manpower to move goals of varied sizes and weights. Moveable soccer goals
should only be moved by authorized personnel.
6. NEVER allow anyone to climb on the net or goal framework.
7. Moveable soccer goals should only be used on LEVEL fields, NEVER on a
slope or hill area.
8. Remove nets when goals are not in use.
9. Most of the tip-over injuries occurred when goals were unattended. Anchor
or chain one goal to another or to nearby fence posts, dugouts, or any other
similar sturdy fixture when not in use. If this is not practical, store moveable
soccer goals in a place where children cannot have access to them.
10. Fully disassemble goals for seasonal storage.
NZ409 Rev. 12/01/16

3. Lay out crossbars and posts, take note of the direction of stickers
on posts. Weave net on to one crossbar using top corner tags as
a guide. Connect all crossbars and 92° crossbar corners.
92° Crossbar Corner
92° Crossbar Corner
Top Corner Net Tag
Post
Post
Crossbar w/ Swage
Crossbar w/ Swage
Crossbar
92° Mark
KWIK GOAL sticker
Warning sticker
92° Crossbar Corner
Post
Push
Crossbar w/ Swage
Crossbar w/ Swage
Crossbar
Push
Top Side Bar
Top Corner Tag
Net
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16

Cable Tie
92° Crossbar Corner
Cable Tie
Top Corner Tag
4. Spread net along assembled crossbars. To secure net to the
corners, insert plastic cable ties into each 92° crossbar corner.
5. Secure corners of net with cable ties, using top
corner tags as a guide.
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16

Post
Ground Shoe
Spike Cap
6. WC-240AS - skip to step 10 for WC-240 continue to step 7.
7. Connect ground shoes to post and remove spike cap from
ground shoe.
OR
WC-240
Ground Shoes (2)
(Part# PT156 set of 2)
WC-240AS
All Surface Shoes (2)
(Part# WC-ASK set of 2)
Post
Assembled
Ground Shoe
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16

Lift
Post
Post
WARNING
UNDER NO CIRCUMSTANCES SHOULD A HAMMER BE USED TO HIT GROUND SHOE INTO SOIL.
USING A HAMMER ON GROUND SHOE WILL CAUSE DAMAGE TO GROUND SHOE.
A PILOT HOLE PEG HAS BEEN PROVIDED FOR HARD SOIL CONDITIONS.
Step 9.1
Pilot Hole Peg
1” to 2”
Hammer into
ground until 2” of
pilot hole peg left.
Post
Ground Shoe
Place one foot on ground shoe plate as
close to the post as possible and push into
ground until ground shoe is completely in
the ground
Step 9.3
Step 9.2
Pull pilot hole peg
straight out of hole
9. Push one ground shoe into field surface with foot as shown in step 3. If soil conditions are hard, mark
ground shoe location and use pilot hole peg and follow steps 9.1 through 9.3.
8. Training frame is designed for one person set up, so lift
one post at a time and stand goal up.
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16

10. If using spiked ground shoes, skip to step 11. Training frame is
designed for one person set up, lay all surface shoes at each
post at desired location. Lift one post at a time and connect all
surface shoe to post, repeat for opposite post.
Lift
Post
Post
All Surface Shoe
All Surface Shoe
All Surface Shoe
Post
Post
All Surface Shoe
All Surface Shoe
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16

11. After one ground shoe is in place move opposite shoe in or out to get posts plumb and crossbar level.
KG
Post Post
Crossbar
Field
Surface
Down - Bow
Up - Arch
Cause Bow
in Crossbar
Cause Bow
in Crossbar
Cause Arch
in Crossbar
Cause Arch
in Crossbar
12. The net of the NXT training frame can be fastened in various configurations to determine ball reaction.
See the following diagrams for suggestions.
12.1. To allow balls to pass through the net, tie only the top
ropes tightly to each post. Leave all others untied.
KG
Post
Tie rope
tight
Post
Tie rope
tight
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16

KG
Post
Weave net
on full length
of posts
Weave net
on post in
this area
Tie ropes
tight
Tie ropes
tight
Tie ropes
loose
Do not tie
KG
Post
To view videos on Kwik Goal product instructions, drills and demos please visit kwikgoal.com/videos.
12.2. To allow low balls to pass through the net, and high balls to remain with the shooter,
weave the top half of the net onto the posts and tie the top two ropes tightly to each post.
Tie the third and fourth ropes loosely around posts. Leave bottom rope untied.
12.3. To stop all balls, weave net onto full length of post on both sides. Tie fourth
ropes tightly at bottom of each post. Leave all other ropes untied.
***CAUTION***
This training equipment has been designed to be used for training only. Training equipment must be anchored AT ALL
TIMES and shall be secured against overturning. Do not climb on the net or frame at any time! All fastenings must be
checked to insure they are fully secured before and after each use of this product. Training equipment not in use must
be disassembled and properly stored in a safe, secure area. Assembled training equipment should not be left
unattended. Do not use this equipment during the threat of high winds. Training equipment should be checked for
safety before and after each use. All warning and safety labels included with this product must be visible at all times.
Any modifications to this or any Kwik Goal product will void any and all warranties.
NZ409 Rev. 12/01/16