Kyocera 6841 Series User manual

106-03-003 © 2023 KYOCERA Corporation
No. : 205-03-287
取扱説明書
INSTRUCTION MANUAL
6841
Series
0.3mm PITCH FPC CONNECTOR
A DCN22680 2023/03/01 R. Nakajima N. Nakajima
O EDN-187 2019/04/14 N. Kitagawa Y. Fujii
NO EDN/DCN DATE PREPARED by CHECKED by APPROVED by

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 1/7
目 次
TABLE OF CONTENTS
1. 概要 OUTLINE ······················································································································································································ 2
2. 6841 シリーズ 各部の名称 SERIES 6841 NAME OF EACH PART ·············································································· 2
3. 取り扱い上の注意 PRECAUTIONS IN HANDLING ············································································································ 2
基板搭載について MOUNTING ON THE BOARD ············································································································· 2
4. FPC 装着作業手順 HOW TO ENGAGE AN FPC ·················································································································· 3
5. FPC の屈曲について FLEXION OF FPC ···································································································································· 7
6. その他の注意事項 OTHER CAUTIONS ···································································································································· 7
7. 製品の保管及び管理 STORAGE MANAGEMENT ·············································································································· 7

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 2/7
1. 概要 OUTLINE
本製品 6841 シリーズコネクタは、0.3mm ピッチ の FPC 用縦型 ZIF タイプコネクタです。
こ こ で 、 6841 シリーズコネクタの取り扱い上の注意点について記載します。
6841 Series is a 0.3mm-pitch ZIF type FPC connector for vertical connection with FPC.
Since the size of this product is very small, it requires careful handling. Please follow instructions described
below.
2. 6841 シリーズ 各部の名称 SERIES 6841 NAME OF EACH PART
3. 取り扱い上の注意 PRECAUTIONS IN HANDLING
基板搭載について MOUNTING ON THE BOARD
基板搭載は基本的に実装機にて行って下さい。 補修などで手のせをする場合は、コンタクトテールに
触れないようご注意下さい。
Basically connectors shall be mounted by the mounting machine. In case of manual
mounting, do not touch contact tails.
インシュレータ
スライダー
コンタクト

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 3/7
4. FPC 装着作業手順 HOW TO ENGAGE AN FPC
（１）「スライダー」を開ける Open the slider
「スライダー」を図のように引き上げてください。一定の高さ（約 1.１mm）までしか上がりませんので、
硬くなったらそれ以上無理な力を加えないように注意してください。
Pull up the slider in the direction shown by the arrow in the figure. Since the slider is lifted up
approximately 1.1mm at maximum, do not apply any further force when it stops.
(注)スライダーはロック状態で納入されます。
(Note) The slider is closed and locked when shipped.
スライダーを持ち上げる時は水平に持ち上げること
Don’ｔ pull up the slider at tilt.

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 4/7
（2）FPC を挿入する Insert the FPC into the connector.
図のように、FPC をインシュレータの底に突き当たるまでしっかり挿入してください。
Insert the FPC into the connector until it hits the bottom inside the connector
as shown in the figure.
【スライダー開放時 When opening the slider】
正常挿入
Proper Insertion
斜め挿入 挿入量不足
Oblique Insertion Insufficient Insertion

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 5/7
（３）「スライダー」をロックする Close and lock the slider.
（２）図の位置まで FPC を挿入後「スライダー」を下方向にしっかり押し下げてください
After inserting the FPC completely, depress the slider firmly.
（４）「スライダー」を開ける Open the slider.
（１）と同じ作業で「スライダー」のロックは解除され、容易に FPC は矢印の方向へ取り外すことが出来
ます。
Pull up the slider in the direction shown by the arrow in the figure and pull up the FPC.
スライダーを挿入する時は水平に押し下げること
Don’ｔ push down the slider at tilt.
スライダーを持ち上げる時は水平に持ち上げること
Don’ｔ pull up the slider at tilt.

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 6/7
（５）FPC を抜去する Pull out the FPC.
図のように、FPC を垂直方向に引き抜いてください。
Pull out the FPC from the connector vertically.

6841 SERIES INSTRUCTION MANUAL No. 205-03-287
106-03-004 © 2023 KYOCERA Corporation PAGE 7/7
5． FPC の屈曲について FLEXION OF FPC
FPC の屈曲により、コネクタ接点部に過剰な負荷が掛からないようご注意下さい。
尚、FPC をコネクタのカード挿入口近くで繰り返し屈曲させ使用する場合はご相談下さい。
条件によっては弊社にて評価確認を行います。
Pay attention not to apply an excess load to the connector contacts, because of the flexion of FPC .Please
contact us when the FPC has to be bent repeatedly near the card insertion opening.
We will conduct evaluation tests according to conditions.
6. その他の注意事項 OTHER CAUTIONS
納入時は、エンボステープ仕様でコンタクトテールは保護されていますが、投げたり、大きな衝撃を加えたりし
ないようご注意下さい。
Do not throw products or apply large shock to them, though contact tails are protected in the embossed
tape when delivered.
7. 製品の保管及び管理 STORAGE MANAGEMENT
製品は、常温、常湿、塵の無い環境下で保管して下さい。
コネクタをエンボステープから取り出した状態（バラ状態）で保管する場合、コンタクトテールに外力が加
わらないようご注意下さい。
Store connectors under normal temperature, normal humidity and no dust condition.
When storing connectors out of the embossed tape, do not apply any pressure to contact tails.
可能な限り長くしてください。
As long as possible.
ｺﾈｸﾀ
connector
FPC