LA CROSSE CLOCK 404-4525 User manual

10-Inch Night Vision
Wall Clock
Model: 404-4525
DC: 110420
This product is warranted to be free from defects in material
and workmanship under normal use and service for a period
of 2 years from the date of sale to the customer. Warranty
will not apply to defects resulting from abuse, accidents, or
misuse. If a defect that is covered by this warranty arises
during the warranty period, promptly return the clock
(postage prepaid) with proof of purchase showing the date
the clock was purchased to the following address and such
defects will be repaired, or the products will be replaced at
La Crosse Clock Company option without charge.
La Crosse Clock Company
Warranty Department
2830 South 26th Street.
La Crosse, WI 54601
www.lacrossetechnology.com/support
Warranty & Support
Made in China - Printed in China
WARNING: This product can expose you to chemicals including
styrene, which is known in the State of California to cause cancer.
For more information go to: https://www.p65warnings.ca.gov/

• Always purchase the correct size and grade of batteries most
suitable for intended use.
•Do not mix old and new batteries.
•Do not mix Alkaline, Lithium, standard, or rechargeable
batteries.
• Clean the battery contacts and also those of your clock
prior to battery installation.
• Ensure the battery is installed with correct polarity (+ and -).
• Remove battery from equipment when it is not used for an
extended period of time.
• Promptly remove an expired battery.
• The specs of this wall clock may change without prior notice.
• Improper use or unauthorized opening of housing voids the
warranty.
Care & Maintenance
• Battery Requirements: 1 AA (IEC LR6) required in the
Movement (Alkaline recommended)
3 AA (IEC LR6) required for the Light Sensor
• Battery Life: 12 months
Specifications
Power Up
1. Insert 1 fresh AA, LR6 1.5 volt alkaline battery into the
Movement, according to the polarity markings.
2. Insert 3 fresh AA, LR6 1.5 volt alkaline batteries into Night
Vision Compartment, according to polarity.
IMPORTANT: Be sure all batteries are of the same voltage
level.
3. Rotate the Time Set Wheel to set the time.
4. Mount on your wall and enjoy!
Learn more from our video: bit.ly/wallclock_setup
Time Set
Wheel
Movement
Night Vision
Compartment
Light Sensor
ON/OFF Switch
Light Sensor
There is a Light Sensor on the front of the clock.
Light Sensor Switch ON: Your clock will light up in the dark
providing the Night Vision.
Light Sensor Switch OFF: Your clock will not light up at night
to conserve batteries.
Note: The quartz movement will keep the clock running
accurately. If the clock does not operate, or steadily loses
time, replace the battery.