1.
be mounted to a wall stud, if possible. One set of mounting screws are included. If it is not possible to
expandable screw anchors. For any other type of mounting scenarios (concrete block, etc.) please
consult your local hardware store for assistance.
2. Use the provided Mounting Template to place your Mounting Bracket onto the wall with the tabs
facing up and away from the wall, making sure it is level, mark the locations of the screw holes. If
necessary, pre-drill your holes and use the supplied Wall Anchors. Fasten the Mounting Bracket to
wall using the supplied screws.
3.
position of the mounting bracket slots.
4.
hose, but DO NOT overtighten. Use a wrench to hold the hose bib secure while tightening the hose
connection.
5.
to your Cold Water Supply Faucet. Make sure rubber washers are in place and properly tighten,
but DO NOT overtighten. Again, use a wrench to hold the hose bib secure on the PLATINUM Ionic
Be sure the cold water connection has a shut-off valve and that hose connections are tight.
CLOSE the shut-off valve at the end of each wash.
6. Plug the power adapter into the DC adapter plug-in on the right side of your PLATINUM IonicLaundry
the adapter into a wall outlet.
7. Ensure all hoses are properly installed and tightened, and that the power supply has been properly
if leaks are apparent, but DO NOT overtighten.
