Landscape Fusion A1000 User manual

ASI 260A HRD95
Assembly Instructions for A1000, D6005DTC, Ad plate products with decals
A
SSEMBLY INSTRUCTIONS
Landscape Brands
211 N. Lindbergh Blvd.
Saint Louis, MO 63141-7809
800-231-1327
Fax: [phone]
E-mail: [e-mail]
Web: www.landscapebrands.com
Assembly Recommendations
To prevent scratching on any of the finished pieces, we recommend assembling the unit on packing material (paper and
cardboard). Do not drag assembled unit on any surface. The assembly is a two-person operation.
Mounting Recommendations
For surface mounted products we recommend the use of stainless steel fasteners.
For inground mounted products follow the assembly instruction recommendations.
Cleaning Recommendations
For cleaning, use mild household cleansers or soap and water. Do not use vinyl cleansers or protectants.
Parts List
1 – Ad Plate (round or square)
1 – Receptacle (D6005DTC)
1 – Liner (D6005DTC)
1 – Dome Top Lid (D6005DTC)
Hardware Included
2 – 7/16” Flat Washer
2 – 5/16” Flat Washer
2 – 1/4" Flange Nut
Tools Needed
Ratchet
7/16 Socket
D6005DTC
SHOWN WITH ROUND AD PLATE
SHOWN WITHOUT LID, LINER, AND
RECEPTACLE DETAIL FOR CLARITY
A1000 (ROUND) A1000 (SQUARE)

ASI 260A HRD95
A
SSEMBLY INSTRUCTIONS
Landscape Brands
211 N. Lindbergh Blvd.
Saint Louis, MO 63141-7809
800-231-1327
Fax: [phone]
E-mail: [email protected]
Web: www.landscapebrands.com
Note:
1. Place the ad plate in the desired location on the receptacle allowing the studs to go through the
perforations in the receptacle.
2. Place a 7/16” washer over the top stud inside the receptacle, followed by a 5/16” washer and
then a nut as shown in Diagram #1 and Diagram #2. If necessary, push on the center of the ad
plate as shown in Diagram #1 to facilitate threading the nut onto the stud. Leave the nut
finger tight.
3. Repeat Step #2 for the bottom stud.
4. Make any desired final adjustments to the position of the ad plate on the receptacle and then
tighten the nuts using the ratchet and the 7/16” socket. Retighten hardware two weeks after
initial assembly.
Diagram #1
Diagram #2
Furniture should not be used other than for its intended purpose and should be inspected regularly for loose, missing, or broken
hardware, and general instability. Furniture that is damaged or appears to be unstable should be removed from service and
immediately repaired or replaced. Repairs should be made using only factory authorized parts and methods. 800-231-1327
! WARNING
NUT
5/16" WASHER
7/16" WASHER
RECEPTACLE
ADPLATE
TOP VIEW
LOOKING DOWN
PUSHHERE