Lanpro LP-SG2402FP3 Series User manual

Active Products - Switches
www.lanpro.com
LPSG2402FP3x_M123_ENB01W
LP-SG2402FP3x
1 2 3 Manual for Power Supply Voltage range change
from 100-120VAC to 200-240 VAC
The LP-SG2402FP3x is a 24 x 10/100 Mbps 802.3af PoE Ports Switch
without Management + 2 x 10/100/1000 Mbps Dual Uplink Copper or SFP
Ports that has a two Input Voltage range power supply.
It comes standard with the 100-120 VAC voltage range unless it was
ordered from the factory with the desired range. In this case, it must be
changed to the 200 to 240 VAC range, when the local mains power voltage
is between 200 and 240 VAC.
In order to change the standard range to the 200 to 240 VAC range,
please follow the next steps.
In order to make the range change, the “Warranty Void if Broken” label
must be broken to access the screw under it. This will void your warranty
unless you ask your preferred LanPro Inc. local representative to make
this change for you for a nominal charge and replace the warranty label.
LP-SG2402FP3x
1 2 3 Manual for Power Supply Voltage
range change from 100-120VAC
to 200-240 VAC
Opening the chassis
1

www.lanpro.com
Active Products - Switches - Rack Series - LP-SG2402FP3x
1 2 3 Manual for Power Supply Voltage range change from 100-120VAC to 200-240 VAC
2
In order to open the Power Supply Chassis, please unscrew three front top screws, 6 lateral and 4 back screws. Please refer
to Figure 1.
Figure 1

www.lanpro.com
Active Products - Switches - Rack Series - LP-SG2402FP3x
1 2 3 Manual for Power Supply Voltage range change from 100-120VAC to 200-240 VAC
3
Locating the Range switch
Changing the Voltage range
Changing the Input voltage range label to reect the new range
2
3
4
Locate the voltage range
selector, it is on one side of
the power supply module as
shown in Figure 2.
You can change the input power voltage range, we suggest that you use the tip of a at screwdriver to ip the selector
switch to the right until the 230 V Range value appears in the window as shown in Figure 3.
Please peel off the backing of the replacement new range label and align and adhere over the old label as shown in Figure 4.
Figure 2
Figure 3

www.lanpro.com
Active Products - Switches - Rack Series - LP-SG2402FP3x
1 2 3 Manual for Power Supply Voltage range change from 100-120VAC to 200-240 VAC
4
Closing the switch chassis
5
Now we can close the chassis again, rst by aligning the cover. Please refer to Figure 5.
Figure 4
Figure 5

www.lanpro.com
Active Products - Switches - Rack Series - LP-SG2402FP3x
1 2 3 Manual for Power Supply Voltage range change from 100-120VAC to 200-240 VAC
5
Tightening the screws.
6
Begin presenting the top screws but without tightening, it will be done once all the screws are in place. Once all screws are
presented into their sockets, carefully tighten them without excessive torque, to avoid damaging the threads, once done
the purpose of this manual is complete. Please see Figure 6.
Figure 6
LanPro is continuously improving its products and reserves the right to change specications and availability without prior notice.