Lantech IPES-0104FA User manual

1
IPES-0104FA
4 10/100TX PoE at/af + 100FX Industrial Switch
Quick Installation Guide
Introduction
The Lantech IPES-0104FAis a 4 x 10/100TX + 1 100FX with 4-PoE-injector Industrial PoE+ Switch feeding up to
30W/port for plug-and-play installation. This slim switch is Wall-mountable or DIN rail mountable, making installation
easier and flexible.
The IPES-0104FAis designed to meet with critical network environment with IP 30 enclosure and test under extensive
Industrial EMI and Safety standards. It supports EFT protection for 2000VDC power and 6000VDC ESD contact
protection, which can reduce unstable environment damage caused by power line and Ethernet. The IPES-0104FA also
supports IEEE 802.3at/af standard for PoE/PoE+ auto-detection and PoE classification resistors for hand-shaking with PD
(power device), which can prevent any connected devices from burning down by sending high voltage (48V) out.
The Lantech IPES-0104FAis the best Industrial switch to connect with IP Camera, Wireless Equipments where are placed
outdoor or tight space cabinets such as street cabinet, wireless hotspots etc.
Housing dimension

2
Installation package
This unit can be installed by din-rail mounted or wall-mounted. Din-rail brackets and wall-mounted bracket are included.
Power and alarm relay connection
The PWR1 and PWR2 can be redundant with each other or you can use one of them to supply the switch.
The middle contact was designed for alarm relay connection.
Power Supply:
44~56 VDC
LED indicator
5
ON –port 5 FX fiber is detected
OFF –port 5 FX fiber is not detected.
Flashing –port 5 FX fiber is active
PWR1
ON -- when V1+, V1- is connected
LNK /ACT
ON—TX link is detected
OFF –TX port is not detected
Flashing –TX port is active
6 pin Terminal Block x1
PWR2
ON -- when V2+, V2- is connected
FAULT
ON –
connect only PW1 or PW2.
OFF-
both PW1 and PW2 are connected

Recommendation for Shielded network cables
STP cables have additional shielding material that is used to reduce external interference. The
shield also reduces the emission at any point in the path of the cable. Our recommendation is
to deploy an STP network cable in demanding electrical environments. Examples of
demanding indoor environments are where the network cable is located in parallel with
electrical mains supply cables or where large inductive loads such as motors or contactors are
in close vicinity to the camera or its cable. It is also mandatory to use an STP cable where the
power device (like IP camera) is used outdoors or where the network cable is routed outdoors.