Larson Electronics DCP-1205 User manual

DCP-1205
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com
1of 3
70W Power Supply - 115V AC to 12V DC - 5A Constant/7A
Surge - Screw Terminal Connectors
Instruction Manual
GENERAL SPECIFICATIONS.
ELECTRICAL:
(A-1) INPUT RATING.
INPUT VOLTAGE 105-125 VAC (115V NORMAL).
NPUT LINE FREQUENCY: 60Hz.
INPUT POWER: MAX. 70W
(A-2) OUTPUT RATING.
OUTPUT VOLTAGE: 13.BVDC ± 0.3V
OUTPUT CURRENT CONT/MAX. 5/7A.
OUTPUT RIPPLE: 150mV RMS
(A-3) REGULATION
LOAD REGULATION: 2.5%(280mV P-P)MAX.
(A-4) PROTECTION
INPUT LINE PROTECTION: GLASS TUBE FUSE. 1.5A/250V
OVER-LOAD PROTECTION: 7A. +10%~15% (AUTO RESET)
OVER TEMPERATURE PROTECTION
(A-5) EFFICIENCY:60% MIN.
(A-6) DESIGN LINEAR TYPE
(A.-7) OPERATING TEMPERATURE 0 TO +40 DEG C.
(A-8) STORAGE TEMPERATURE: - 25 TO + 70 DEG C.
• NOTE• INPUT AT 115VAC AND OUTPUT AT CONT CURRENT
MECHANICAL:
(B-1) DIMENSIONS (7.5in.) 190mmx (4.9 in.) 125mm x (3 in.) 76mm. (L xWx H)
(B-2) WEIGHT: (4.9 LBS) 2.1 KGS
(B-3) ENCLOSURE BLACK
(B-4) INPUT CABLE 18AWG x 2C W/1-15P PLUG. SPT-2 6FT
(B-5) OUTPUT TERMINAL BINDING POST. 10A/125V
(B-6) POWER SWITCH ILLUMINATED. 15A/125VAC

DCP-1205
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com
2of 3



 
  

Tl  


I   • 




 Nl�
-

,  N
<
 
 
O
 
      

DCP-1205
Larson Electronics, LLC Phone: [phone] Fax: [phone] www.larsonelectronics.com
3of 3
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
[e-mail] OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR WARRANTY AND RETURN INFORMATION.
OPERATION:
1 INSERT AC POWER PLUG INTO A 110V VOLT AC OUTLET.
2 CONNECT THE POWER CORD OF YOUR EQUIPMENT (13.5V -14.1VDC} TO THE OUTPUT BINDING
POST TERMINALS ON THE FRONT OF THE UNIT. BE SURE THAT POLARITY IS CORRECT. THE RED
POSITIVE (+) TERMINAL AND BLACK NEGATIVE ( -) TERMINAL ARE MARKED. REVERSAL OF POLARITY
MAY DAMAGE YOUR EQUIPMENT.
3 TURN SWITCH TO "ON". RED LIGHT IN SWITCH WILL ILLUMINATE.
4 THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE REAR OF THE UNIT
AND CAN BE REPLACED BY UNSCREWING THE FUSE HOLDER IF THE FUSE IS BURNT OUT DO NOT USE
A FUSE LARGER THAN • • AMPS. USE OF HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT.
5 THIS UNIT HAS ELECTRONIC OVERLOAD PROTECTION WITH INSTANT AUTOMATIC RESET FUNCTION
IF OUTPUT IS OVERLOADED THE OUTPUT POWER WILL AUTOMATICALLY SHUT OFF RELEASE POWER
CORD OF YOUR EQUIPMENT FROM THE OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING
OF YOUR EQUIPMENT THIS UNIT WILL AUTOMATICALLY RESET INSTANTLY.
6 OVER TEM PERATURE PROTECTION CIRCUITRY IS USED IN DCP-1205 TO PREVENT OVER
HEAT DAMAGE UNIT WILL BE SHUT DOWN MINUTES AFTER 15 MINUTES( MIN ) AT 100% RATED LOAD.
25 MINUTES( MIN.) AT 80% RATED LOAD
7. THIS UNIT FEATURED WITH A CAR CIGARETTE JACK FOR THE CONVENIENCE OF YOUR MULTIPLE
CHOICES.
CAUTIONS:
1 DO NOT USE WITH EQUIPMENT REQUIRING MORE THAN RATING AMPS
2 DO NOT USE OUTDOORS DO NOT EXPOSE UNIT TO RAIN, MOISTURE. WATER OR
ANY OTHER LIQUIDS.
3 DO NOT REMOVE COVER IN ANY CASE. RETURN TO DEALER FOR REPAIR IF
DAMAGED.
4 THIS UNIT HAS A SPECIAL BUILT-IN FEATURE THAT WILL SHUT THE UNIT DOWN IF MARKED
AMPERAGE IS EXCEEDED THIS WILL AVOID BURN-OUT OF YOUR EQUIPMENT AND OF UNIT. IF UNIT
DOES CONSISTENTLY SHUTDOWN THIS MEANS YOU ARE DRAWING TOO MUCH AMPERAGE RETURN
UNIT TO PLACE OF PURCHASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER
AMPERAGE. PLEASE DO NOT BYPASS OR ALTER THIS CIRCUIT AS IT IS THERE TO PROTECT YOU ANY
ALTERATION OR MISUSE WILL VOID YOUR WARRANTY
'$1*(5
+,*+92/7$*(
5()(57248$/,),('7(&+1,&,$1)256(59,&(