Installation specification: Before operating LX1, please secure the main unit based on the user manual.
Please place the product on a stable and flat table or workbench. The vibration of the machine will affect the
engraving quality.
Due to the risks of laser, do NOT bring minors or people without self-protection awareness close to the
device in operation.
Before operating the laser module, you should have adequate knowledge of: physical properties of laser
radiation, hazardous classification of laser and relevant health implications and safety measures.
The laser module uses Class 4 lasers. The overall laser becomes Class 1 when paired with a laser protection
cover as required and using the laser module correctly.
When operating the laser module, do NOT look directly at or touch the laser outlet, or expose your body to
the laser.
It is recommended to correctly install and use the official LaserPecker laser protection cover, which can
effectively filter the scattered laser light during laser engraving. After the laser protection cover is properly
installed and powered on, its opening and closing states are linked to the laser emission, that is, the product
will automatically stop laser engraving when the protection cover is opened to prevent laser leakage for your
personal safety.
When the laser module is in operation, the material being engraved or cut may release toxic and harmful
gases or smoke. Please make a comprehensive judgment based on the type and composition of the material,
and use the product with an air purifier or in a well-ventilated place.
Reflective materials can cause laser reflection and injury. Please remove all reflective materials from the
work area before use and during operation. It is recommended to blacken the area to be engraved of the
reflective material by a whiteboard marker beforehand.
Please power the device with the power and type (adapter with 24V 5A) as indicated in the user manual.
Mismatched power adapter will cause the malfunction.
Before initiating the laser module, please make sure to take safety protection measures, such as wearing
safety goggles to prevent eye or skin injury, removing irrelevant objects to prevent unnecessary damage
caused by laser irradiation, and moving away flammable and explosive objects to avoid fire.
After initiating the laser module, do NOT move the device, otherwise it may cease operation for self-protec-
tion, or even affect the final effect of the engraving work due to displacement.
Please make sure to disconnect the connection cable of the protection cover and main unit, and separate the
device from the outer cover before moving the protection cover or the device.
Do NOT scratch, bend or break the acrylic plate and profiles, or open the cover reversely, as it will impair its
protective performance and cause permanent damage to the cover as well as personal injury.
The protection cover top is designed as a double-door structure. Please do NOT place heavy objects over 5kg
on the top.
Do not put any objects or body parts near or into the exhaust fan when in operation.
All wires must be placed away from the exhaust fan blades to avoid damage to the exhaust fan and other parts
when in operation.
LP Air Purifier can be connected to the exhaust fan to purify and filter the air inside the protective cover for
your health.
2.32 Laser Engraving Safety
2.3.3 Laser Protection Cover Safety
The product has a smell of burning odor.
Engraved material generates a large amount of fumes or open flames.
The internal components of the product have been damaged.
The product stops working accidentally.
The product generates unprecedented abnormal noise or light.
In case of the following situations, please stop using the product and
cut off the power supply immediately.
03
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
·
Do NOT leave the machine unattended during operation.
Please cut off the power supply before switching to laser module.
