Lean Cars CH9958 User manual

CH9958
Children's buggy
Installation and operation manual
Armrest, push rod function
Alarm light function
Executive standard: EN71 and EN62115 ;
GB6675and GB19865
Assembly By Adult Only
Please follow real product, Photo for reference only

The picture in this manual is to show the product operation and structure, please
follow the real product only if any difference between picture and product happens.
There must be chance not to inform you on time to improve the product result from
appearance or structure, please be understood.
Please read this manual carefully before play the product, it tells you the
right way for operation and install to avoid any possible hurt to your kids.
Please keep this manual and put it in a place where is easy to get.
WAARNING:
The following safety hazards may cause serious injury or death
1.Never leave your children unattended
2.Be sure to sit on the seat when using this car
3.Keep your hands, hair and clothes away from moving parts
4.Be sure to wear shoes when operating this car
5.Up to one child is allowed to ride in the vehicle
6.Only on flat roads
7.Do not approach the swimming pool or other water bodies, falling places or steep slopes
8.Do not drive into loose soil.Mud, sand, gravel or wet pavement
9.Do not drive on the road or near the car

部件说明
1
2
4
6
7
9
10
11
8
5
12
3
1 1 1 1
4
1
1
1
1
4
4
7
10
2
5
8
3
6
9
11
Washer 12M8 Nut
4
13
2
8
Serial
No. Serial
No. Serial
No.
Component
Name Component Name Component
Name
Quantity Quantity Quantity
seat
Body
Windshields Rear wheel cover
Wheel Steering wheel Manual
Rear wheel
alignment tube
Armrest left and right
Armrest backrest

1:
2:nstall a gasket on both sides of the wheel, then lock the nut and fix it with an M8 wrench.
Finally, clamp the wheel cover
Install a gasket on each side of the front axle, and then install a wheel on each side of
the front axle
Rear wheel cover
wheel
M8 Nut Washer
Rear wheel
alignment tube
3: Put a gasket, bushing, gasket, wheel and gasket into the right side of the rear axle,
then lock the nut, fix it with an M8 wrench, and finally clamp the wheel cover
4: Put a gasket, bushing, gasket, wheel and gasket into the left side of the rear axle,
then lock the nut, fix it with an M8 wrench, and finally clamp the wheel cover

1.First, insert the connecting line, then insert the wind bracket into the corresponding
holes of the vehicle body with force, so that the wind bracket and the vehicle body are
buckled.(as shown in the figure)
1.Insert the steering wheel firmly into the corresponding hole of the instrument panel to make
the steering wheel and the instrument panel snap together.（as shown in the figure）

1. Clip the armrest back into the seat back slot. The spring shrapnel should be clamped
in place
1.Clip left and right armrest into armrest backrest and secure to steering wheel

7
1. Clip the push rod into the push rod groove of the body. The spring shrapnel should be
clamped in place
1.Open the engine cover and clip the 2 No.5 batteries into the battery box of the alarm light
Spring shrapnel

8
9
Steering wheel
horn
Instrument cluster functions
Alarm light switch

WARNING:
For your baby to drive safely, you must pay attention to the following warnings：
The assembly and adjustment of the product must be carried out by adults. Please keep children
away from moving parts
Small parts inside
Children must use the product under the guidance of adults, and the carer must not leave during
use! Do not get close to the fire
Do not allow children to stand or play on the footboard
In order to avoid harm to children, please keep plastic bags and other packaging materials away
from children! Room breathing danger!
Do not use any accessories not provided by the manufacturer
The maximum load-carrying capacity of the vehicle is 20kg, and overload is not allowed
Applicable age range: 2-4years old