APP COMMISSIONING
The full procedure of the commissioning with the mo-
bile application is explained in separate guidelines
and videos. Please contact info@ledcity.ch for further
details.
LED INDICATORS
The function of the status LED is explained in the fol-
lowing table. There are two colors with two different
meanings – one for Bluetooth Mesh network status
and one for radar sensor status:
GREEN LED (BLUETOOTH MESH NETWORK STATUS)
Fast blink (each 300 ms) Unprovisioned
Slow blink (each 2000 ms) Provisioned
Blink twice (50 ms cycle) Mesh packet received
On / Off (500 ms cycle) Attention event
Long blink Factory reset
BLUE LED (RADAR MOVEMENT SENSOR STATUS)
Blink once Motion detected
The location of the status LED as well as the other sen-
sors (daylight / radar) is shown in the following picture:
RADAR SENSOR
SENSITIVITY
The radar sensi-
tivity can be ad-
justed with the
rotary knob on
the backside of
the sensor
head.
0% = lowest sensitivity / smaller detection range
100% = highest sensitivity / wider detection range
FACTORY RESET
The semiautonomous
plus tube can be reset to
unprovisioned mode by
placing a strong magnet
(e.g. neodymium magnet)
near the right side on the
light sensor position of
the sensor head for 5 se-
conds (as visible in the
following picture on the
left). The factory reset
procedure needs to be
executed with a powered
tube.
Once the factory reset is done successfully, the tube
(lightness output) behaves as follows:
100 %
0 %
50 %
3
6 9
The light sequence above is executed every time du-
ring power-on of an unprovisioned tube.
WIRING DIAGRAM
LEDCITY TUBE
L N
sensor
head
factory
reset
switch
(magnetic)
daylight
sensor
radar
movement
detection
sensor
status
LED
radio
transmitter /
antenna
Date: 28.10.2020
