Ledi RGB-DMX-CONT-STICK-CU4 User manual

Installation
Instructions
for the RGB DMX Stick CU4 Controller
#RGB-DMX-CONT-STICK-CU4

Version 05122017
2
POWER
+DMX
POWER
5V-9V
PORT 2
PORT 1
DMX
8
7
6
5
4
3
2
1
-
+
+
Ground
-
POWER
DC +
POWER
Ground
DMX
Ground
DMX -
DMX +
Other Connections
1
3
5
7
9
11
13
15
17
19
2
4
6
8
10
12
14
16
18
20
NC
NC
PORT8
PORT7
PORT6
PORT5
PORT4
PORT3
PORT2
PORT1
GND_DMX
DMX+
DMX-
NC
NC
NC
NC
NC
GND
VIN
HE10 EXTENSION socket
Compatible header connectors:
><9;/,3,2;96502YLM!
463,?YLM! 
;,*VUULJ[P]P[`YLM!
-*0YLM!3-
/(9>05YLM!4 
:(4;,*YLM!;:>__;+
-(95,33YLM!
9:YLM!
46<:,9YLM! 
+0.02,@YLM!>45+
2. Connect the wires
POWER:*VUULJ[H=((*+*Z\WWS`)LZ\YL[VUV[PU]LY[[OLHUK[OLNYV\UK
DMX!*VUULJ[[OL+4?JHISL[V[OLSPNO[PUNYLJLP]LYZ3,+Z+PTTLYZ-P_[\YLZMVY?39!
$NYV\UK$KT_$KT_
There are 2 ways to connect the power and DMX:
3. Mount the interface on the wall
-PYZ[TV\U[[OLIHJRZPKLVM[OLPU[LYMHJLVU[OL^HSS^P[OVY
TVYLZJYL^Z:LJVUKS`JVUULJ[[OL+4?HUKWV^LYJVUULJ-
[VYISVJRVY91
The front panel is mounted by pressing it against the back plate
and then sliding down. Two screws should then be attached
underneath to hold the controller in place.
DMX CHIP
Solder the DMX chip to the 8 pin connec-
tor on the right of the RJ45 socket. Be
sure that the chip is facing downwards
CHECK PIN CONFIGURATIONS.
APPLYING POWER TO THE
DMX INPUT WILL DAMAGE THE
CONTROLLER
MAKE SURE THE CONTROLLER
IS MOUNTED FLAT WITHOUT
OBSTRUCTIONS FROM BEHIND
AS THIS CAN PUSH APART THE
GLASS
 4V\U[HULSLJ[YPJHSIV_PUZPKL[OL^HSS
The controller can be installed in a standard electrical
IHJRIV_;OPZIV_PZ\Z\HSS`TTOPNOHUK^PKL
L_JLW[PU1HWHUHUK(TLYPJH^OLYLP[PZTT 
inches high. You can insert the AC/DC adapter inside or
V\[ZPKL[OLIHJRIV_
Connector Block RJ45
P1 P2 P3 P4 ... GND
Dry Contact Port Triggering
It is possible to start scenes using the dry
JVU[YHJ[PUW\[WVY[ZH]HPSHISLVU[OL/,
L_[LUZPVUZVJRL[;VHJ[P]H[LHWVY[HIYPLM
contact of atleast 1/25 second must be
LZ[HISPZOLKIL[^LLU[OLWVY[ZHUK[OL
NYV\UK.5+5V[L![OLZJLUL^PSSUV[IL
Z^P[JOLKVɈ^OLU[OLZ^P[JOPZYLSLHZLK
Installing the Controller

Version 05122017
3
Power+DMX
socket (RJ45)
10 mm
106 mm
146
mm
Scene Selection
mini
usb dmx led
data
led
Touch-sensitive
user interface
Extension socket
rear connectors
(2x10 pins)
Screw-terminal
rear connector
(5 pins)
Front access
connections
Dimmer
Color
Saturation
9LZL[
ZLLº*LU[LY)\[[VU»ZLJ[PVUILSV^MVYM\Y[OLY
information
Standby
Center Button
Other Settings
;OLYLHYLZL]LYHSVWLYH[PVUTVKLZMVY[OLI\[[VUPU[OLJLU[LYVM[OLWHSL[[L;OLZLJHUILZL[^P[OPU[OL/HYK^HYL4HUHNLY
Reset color : the color set on the wheel will be cleared and the default scene will be restored.
Play next scene ![OLJ\YYLU[S`ZLSLJ[LKZJLUL^PSSZ[VWHUK[OLUL_[ZJLUL^PSSWSH`
Select next bank!PMTVYL[OHUZJLULZHYLZ[VYLKPU[OLJVU[YVSSLY[OLUL_[IHUR^PSSILZLSLJ[LK6ULVM[OLZJLULZLSLJ[PVU
I\[[VUL^PSSÅHZOMVYZLJVUK[VPUKPJH[L[OLZLSLJ[LKIHURU\TILY
Toggle wheel color/scene mode :[OL^OLLSJHUIL\ZLK[VZLSLJ[HJVSVYVYHZJLULKLWLUKPUNVU[OLTVKL;HWWPUN[OL
I\[[VU^PSS[VNNSLIL[^LLUZJLULZLSLJ[PVUHUKJVSVYZLSLJ[PVUTVKL;OLJLU[LY3,+^PSSISPUR^OLU[OL^OLLSPZZL[[VZJLUL
mode.
Disable button : the button will have no function.
;OLYLHYLZL]LYHSV[OLYZL[[PUNZ^OPJOHYLH]HPSHISL^P[OPU[OL/HYK^HYL4HUHNLY
Miscellaneous:
Name : HJ\Z[VTUHTLMVY[OLJVU[YVSSLY\ZLM\SSPM`V\OH]LZL]LYHSJVU[YVSSLYZJVUULJ[LK
Parameters:
Color/Dimmer : determines whether the color/dimmer will be reset when a new scene is recalled and whether color/dimmer
JOHUNLZHYLZ[VYLKNSVIHSS`VYWLYZJLUL
Re-select scene :KL[LYTPULZ^OH[OHWWLUZ^OLUHWSH`PUNZJLULPZYLZLSLJ[LK
Reset color : JSLHYHU`JVSVYJOHUNLZHUKYLZL[[V[OLZJLUL»ZJVSVY]SH\LZ
Reset dimmer :JSLHYHU`KPTTLYJOHUNLZHUKYLZL[[V[OLZJLUL»ZKPTTLY]SH\LZ
Reset saturation : JSLHYHU`ZH[\YH[PVUJOHUNLZHUKYLZL[[V[OLZJLUL»ZZH[\YH[PVU]SH\LZ
Starting mode (L) : JOHUNL[OLSHUN\HNLVM[OL[L_[^OPJOHWWLHYZVU[OLZJYLLU
Re-select scene :ZL[[PUNZYLSH[LK[V[OL3,+ZVU[OLJVU[YVSSLY
Scene LED light level : ZL[Z[OLIYPNO[ULZZVM[OL3,+Z
RGB LED enable :LUHISLKHUKKPZHISLZ[OL9.)3,+PU[OLJLU[LYVM[OL^OLLS

Version 05122017
4
ESA2 Software >PUKV^Z4HJ
http://www.nicolaudie.com/esa2.htm
Hardware Manager >PUKV^Z4HJ-PYT^HYLJSVJR
O[[W!^^^KT_ZVM[JVTNSVIHSM[WOHYK^HYLTHUHNLYaPW
O[[W!^^^KT_ZVM[JVTNSVIHSM[W/HYK^HYL4HUHNLYKTN
E
S
A2
S
oftware

>PUKV^Z

4HJ

http://www.nicolaudie.com/esa2.htm
H
ar
d
ware
M
anager

>PUKV^Z

4HJ

-PYT^HYLJSVJR

O[[W!^^^KT_ZVM[JVT
N
SVIHSM[WOHYK^HYLTHUH
N
LYaP
W
O[[W!

^^^KT_ZVM[JVT

NSVIHS

M[W

/HYK^HYL4HUHNLYKTN
;OL+4?JVU[YVSSLYJHUILWYVNYHTTLKMYVTH7*VY4HJ\ZPUN[OLZVM[^HYLH]HPSHISLVUV\Y^LIZP[L9LMLY[V[OL
JVYYLZWVUKPUNZVM[^HYLTHU\HSMVYTVYLPUMVYTH[PVU;OLÄYT^HYLJHUIL\WKH[LK\ZPUN[OL/HYK^HYL4HUHNLY^OPJOPZ
included with the programming software.
Programming the Controller
Troubleshooting
;OLJVU[YVSSLYPZPUIVV[SVHKLYTVKL;OPZPZHZWLJPHSºZ[HY[\WTVKL»
^OPJOPZY\UILMVYL[OLTHPUÄYT^HYLSVHKZ
-Check that there is nothing metallic touching the back of the controller
;Y`YL^YP[PUN[OLÄYT^HYL^P[O[OLSH[LZ[OHYK^HYLTHUHNLY
5VZOV^ÄSLOHZILLUKL[LJ[LKVU[OLJVU[YVSSLY
-Download the latest software
<WKH[L[V[OLSH[LZÄYT^HYL\ZPUN[OLPUJS\KLK/HYK^HYL4HUHNLY
;Y`YL^YP[PUN[OLZOV^ÄSL
*LU[LY3,+9LKJ`JSPUNWH[[LYUVU3,+Z,YYVY
*LU[LY3,+.YLLUJ`JSPUNWH[[LYUVU3,+Z,YYVY
*LU[LY3,+)S\LJ`JSPUNWH[[LYUVU3,+Z,YYVY
-Be sure that the latest software version is installed (use the beta if
H]HPSHISL
*VUULJ[I`<:)HUKVWLU[OL/HYK^HYL4HUHNLYMV\UKPU[OLZVM[^HYL
KPYLJ[VY`0MP[»ZKL[LJ[LKOLYL[Y`[V\WKH[L[OLÄYT^HYL
;Y`HUV[OLY<:)JHISLWVY[HUKJVTW\[LY
*OLJR[OL+4?HUK.5+HYLJVUULJ[LKJVYYLJ[S`
*OLJR[OH[[OLKYP]LYVYSPNO[PUNÄ_[\YLPZPU+4?TVKL
-Be sure that the DMX address has been set correctly
-Check there are no more than 32 devices in the chain
*OLJR[OH[[OL+4?3,+PZÅPJRLYPUN[V[OLYPNO[VM[OL:+JHYK
*VUULJ[^P[O[OLJVTW\[LYHUKVWLU/HYK^HYL4HUHNLYMV\UKPU[OL
ZVM[^HYLKPYLJ[VY`6WLU[OL+4?0UW\[6\[W\[[HIHUKTV]L[OLMHKLYZ
0M`V\YÄ_[\YLZYLZWVUKOLYLP[PZWVZZPIS`HWYVISLT^P[O[OLZOV^ÄSL
All 7 LED’s on the controller are blinking The 6 scene LED’s are blinking
Contact us if you see the following errors
The controller is not detected by the computer
The lights are not responding
Instructions provided by Nicolaudie-Sunlite
For additional assistance, please contact LEDI’s Design Department at
[phone], or [e-mail].

Version 05122017
5
RGB DMX Stick CU4
Complete System Wiring Diagram
120-277V
AC Power
RGB Tape Light
RGB Tape Light
RGB Tape Light
CAT-5 CAT-5
CAT-5
RGB Hardwire Connector
RGB Hardwire Connector
RGB Hardwire Connector
RGB DMX Decoder
RGB DMX Decoder
RGB DMX Decoder
RGB DMX
Terminator
120-277V
AC Power
120-277V
AC Power