Ledra Brands ALPHABET User manual

SHOPLINESHOPLINE
www.moltolucelighting.comMolto Luce By Ledra Brands 15774 Gateway Circle Tustin, CA 92780 PH: 714.259.9959FAX: [phone]

SHOPLINE
Chain hanger Cord hanger Rod hangerSurfacing mounting kit
LED Linear Lighting System- Installation Manual
Wire diagram ofTriple Circuits function
Five options for power feed in Remarks:
9
10
Node connectors L,T,X can be used to turn the lighting directions
Node connector L Node connector T Node connector X
Four options for installation
First trunking rail should have one side connecting plate&last
trunking rail with no connecting plate on both sides , then x
the Luminaire to trunking rail then slide the locks, cover with
protection caps, then keep end caps at both sides.
This Triple Circuits function offers to control lighting ON/OFF by three
switches SW1,SW2,SW3 which are connected by live lines L1,L2,L3
Pendant and mounting installation
Starting Installation distances point should be 800 mm to 1000 mm,
then in between 1st & 2nd point should be 3000 mm max
Emergency luminaire
Emergency driver
• Keep batteries away from direct sunlight , high temperature and high humidity.
• During long terms of storage, battery should be recharged at least once time a
month for longer life time of battery
Battery LED driver
L1
L2
L3
FG
N
SW1
SW2
SW3
End cap L:
End cap for double arc
shape PC cover
End cap M:
End cap for lenses cover End cap S:
End cap for blank cover
& Track spot light rail
Power feed in box
Connect the power cable wires accordingly to power feed in box
then push to trunking rail to click
Using power feed in node connectors connect power cable wires
accordingly to node connectors then push trunking rail or node
connectors to click
Power feed in node connector L,T,X
Central power feed in trunking rail
Connect the power feed in cable from central hole of trunking rail
if there are two feed out connectors on both sides of trunking rail
Normal trunking rail
Unscrew the connector in the trunking rail then fold wires backward to
keep distances from power feed in hole as above picture in box , then
connect the power cable wires accordingly to feed in pin connector
Connect the feed in pin connector to truck rail wires connector then
connect power feed in cable accordingly to feed in pin connector
Terminal feed in trunking rail
• Wire to battery is disconnected during shippment. Reconnect it before installation.
Trunking Rail
Connecting plate
Power cable feed in hole
Luminaire
Driver
Sliding lock
Protection cap
End cap
1
2
3
4
5
7
8
Rail lock
Male connector
9
10
6
11 Female connector
11
www.moltolucelighting.comMolto Luce By Ledra Brands 15774 Gateway Circle Tustin, CA 92780 PH: 714.259.9959FAX: [phone]