Leenders LOBBE COMPACT User manual

LOBBE COMPACT
INSTALLATION EN

LOBBE COMPACT LEENDERS
201847.001.I.EN
Points of aenon installaon Lobbe Compact
Tool required:
• Concrete drill bits Ø6 and Ø14
• Allen key 4mm
• Socket spanner 17mm
• hammer or frozen pear
The Lobbe Compact can only be mounted to a solid and robust wall. The rear wall must
not be combusble. The Lobbe Compact is not suitable for a rear ue.
Transport
Move the Lobbe Compact with a hand
truck supported against the back.
Remove the poker
Break the poker free from the wall
bracket. The customer can nish the
poker. See separate instrucons.

LOBBE COMPACT LEENDERS
201847.001.I.EN
Fresh air supply (oponal)
Centre of fresh air opening in rear wall 490mm, diameter minimum Ø110mm.
Connect the exible pipe to the fresh air supply in the back of the Lobbe Compact. Adjust
the length of the exible pipe if necessary.
Wall bracket
Draw centre line. Mark the top
holes for the wall bracket on
the centre line at 770mm
from the oor.
Pre-bore (6x) holes with the
Ø6 bit. Then bore with the
Ø14 bit.
Fix the wall bracket to the
wall with 6x anchors + 6x
Allen key bolts M8.
Fix the at band (2x) to the
vercal strips on the wall bracket.

LOBBE COMPACT LEENDERS
201847.001.I.EN
Mounng the Lobbe Compact
Li the Lobbe Compact with no fewer
than two people. Insert locking wedges
(2x). Secure the locking wedges (2x) with
a tap only aer levelling.
Adjusng for level (if required)
Tighten the 2x M10 adjustment bolts at
the boom of the wall bracket to level.
Secure the locking wedges (2x) with a tap
of a hammer or frozen pear.
Side les
Use the sets of gloves supplied. Posion the rst side le. Secure it from the inside with
2x M10 bolts and underneath with 1x M10 bolt. Posion and secure the second side le.
M10
M10
M10
M10 M10

LOBBE COMPACT LEENDERS
201847.001.I.EN
Knob air valve
2x M4 Allen keys at the rear of the air
valve.
Interior
Posion the air pipes 2 sets.
Check that the air pipes are properly connected at the boom.
Posion the heat shield.
Check that the heat shield is properly seated at the boom.

LOBBE COMPACT LEENDERS
201847.001.I.EN
Inspect
Aer ng the Lobbe Compact, the following points deserve extra aenon:
• Check if the Lobbe Compact is xed securely.
• Ensure that there are no combusble and/or explosive materials (paper, cardboard,
spray cans, etc.) in or close to the Lobbe Compact.
• Check, if the ue allows for this, the operaon of the ue and the air supply to the
Lobbe Compact with a re. Follow the instrucons in the manual for this.

LOBBE COMPACT LEENDERS
201847.001.I.EN
General instrucons and regulaons
Installaon
To qualify for the guarantee, the Lobbe Compact must be installed by a qualied er employed by a
Leenders approved dealer. See leenders.nl for a current list of addresses of approved dealers or con-
tact the factory.
The stove is suscepble to scratching, cauon is recommended.
Stoke the stove aer ng with kindling to check the dra.
Use
• All local regulaons, including those referring to naonal and European standards must be
observed when ng the appliance.
• Ensure ample venlaon / air supply in the room where the stove is installed. Air extracon, such
as an extractor hood, can cause problems in the form of ue gases escaping from the stove into
the room.
• This appliance is not suitable for sharing a ue.
• The appliance must be ed to a wall that can easily support the load.
• Ensure there is ample access for cleaning the equipment, the ue gas connecon and the chimney.
Safety regulaons
• Glass is very fragile and broken glass is very sharp. Take sucient safety precauons.
• For maers of general safety, the appliance and locaon should meet naonal and local installaon
regulaons, local re brigade regulaons and required architectural provisions.
• Please note: that aer installaon no combusble and/or materials with a danger of exploding
should be placed in the stove, like spray cans, packaging materials and such like.
Safe distance for Lobbe Compact from combusble materials
• Rear wall; appliance must be mounted on a non-combusble wall.
• Side walls; 350mm. Temperature during safety test; 54°C
• Front; 1200mm. Temperature during safety test; 47°C
Specicaons Lobbe Compact
• Nominal capacity = 5.2 kWh
• Flue gas mass ow = 5.8 g/s
• Mass appliance = 108 kg
• Minimum chimney draught = 0.12 mbar
• Flue gas temperature directly above the stove = 211 °C
• Energy Eciency: 80.9%, Class A+, index 108.3
A
+