2
Connecting the Printer to Your iOS Device
On initial setup, and later, in the absence of a recognized network, your printer will switch to what is
known as "Soft AP" mode, where the printer creates it's own Wi-Fi network for wireless printing.
When connecting your printer to an existing network, you will use Soft AP mode to connect to the
printer and select the home or office network to which you want the printer to be attached. Later, if
you move the printer to another location where the network is not available, the printer will switch
back to Soft AP mode so you can connect to it and print using its own broadcast network.
Connecting the Printer to Your Network
1. On your iOS device, search for available wireless networks.
2. From the list of available networks, select your Printer ID.
The Printer ID is formatted as ICON-xxyyzz and can be found on the label on the bottom of
your printer.
3. Once connected, start a web browser on your iOS device.
4. In the address bar, type 192.168.1.1 and then press Enter.
5. Enter your user name and password in the User name and Password boxes.
The default user name and password are as follows.
User name: admin
Password: password
You can change this user name and password at any time; see the Leitz Icon Printer User
Guide for more information.
6. Click OK.
The Leitz Icon Control Panel is displayed.
7. Click Wi-Fi Setup Wizard.
8. Click Connect to Existing Network.
The Select Your Wireless Network page is displayed.
9. Select your wireless network in the Available Networks list.
10.If prompted, enter your network password and then click OK.
11.Click Next.
The Connection Settings page is displayed with the most common, default setting selected.
12.Unless you are performing an advanced installation needing a specific static IP address,
click Next to use the default settings.
13.On the Confirm & Connect page, click Connect.
As the printer connects to the selected network, you may hear a noise as the printer resets. At
the same time, the wireless connection from your computer to the printer is dropped and you
will need to reconnect your computer to your wireless network.
14.Close the Leitz Icon Control Panel.
NOTE If the label on the bottom of your printer does not contain the Printer ID, you can determine the
Printer ID using the printer’s MAC address. In this case, the Printer ID is formatted as ICON-
xxyyzz, where xxyyzz is the last six characters of your printer’s MAC address (found on the label
on the bottom of your printer). For example, if your printer’s MAC address is
MAC:00:1E:CO:13:13:A5, the Printer ID is ICON-1313A5.
