LEPARD EM.033 User manual

 LEPARD
www.lepard.eu
LEPARD
AUTOMOTIVE GROUP :: LPG/CNG SYSTEMS
-
tel.[phone] | e-mail: [email protected]

EM.033
EM.033.1
EM.033.2
1.13ML : 08/2015
Fuel Pressure Emulator
Installation and Operation Manual
GB
Emulator Ciśnienia Paliwa
Instrukcja 
PL
Üzemanyag nyomás Emulator

HU
Fuel Pressure Emulator
B Installations- und Betriebshandbuch
DE
AT
CH
Emulátor tlaku pali

CZ
Эмулятор давления топлива

RU

|A
A
Przykład podłączenia emulatora EM.033.1

|B
B
Przykład podłączenia emulatora EM.033.2
(podłączenie do wtryskiwacza)
\

GB|1
INTRODUCTION
Fuel Pressure Emulator to cars fuelled with LPG/CNG. Is applied in cars, in which when running on gas
ECU reports an "Error too high pressure in the fuel terminal ".
When you work on gas, as a result of the lack of delivery of petrol with strips of tank, the pressure of
petrol rises above the value expected. As a result, the ECU, reduces lead times-injection petrol and
signals the error. Emulator effectively eliminates this problem by providing the proper level of signal of
pressure.
Emulator is required, in particular for car brands: Ford, Jaguar, Volvo, Mustang. But also in all of these, in
which the pressure sensor is mounted on the fuel terminal.
TECHNICAL DATA
Power Supply
12V ±25%
Operating temperature
-40..90°C
Emulation Voltage Range
0.8 .. 4.8V
Tightness class
IP66

GB | 2
ASSEMBLY
NOTE!
Mounted vertically down while safeguarding against contact with water
Mount away from strong sources of heat (i.e. the engine block or in the vicinity of the
exhaust manifold).
Mounted away from the ignition and high voltage cables
1. Locate the cable signal sensor pressure petrol
2. Mount the Emulator in accordance with the installation diagram .A..
3. When running on petrol (no voltage on the blue wire), at idle, using a multimeter to measure
and store the value of the output voltage pressure sensor, refer to the installation diagram
.A..
4. While working on the gas (about 12V voltage on the blue wire), at idle, using a screwdriver to
set the emulator to the value measured in step 3, i.e. set the emulator voltage (green wire)

PL|1
WSTĘP
          
          

Podczas pracy na gazie, w wyniku braku odbio
            
sygnalizuje 
         u
.
            

DANE TECHNICZNE
Zasilanie
12V ±25%
Temperatura pracy
-40..90°C

0.8 .. 4.8V

IP66

PL|2
MONTAŻ
UWAGA!


wydechowego).

1. na listwie paliwowej.
2. .A..
3. Podczas pracy na benzynie  na przewodzie niebieskim), na wolnych obrotach,

 .A..
4. Podczas pracy na gazie ( ok. 12V na przewodzie niebieskim), na wolnych obrotach, za

.