LevelOne FCS-1030 User manual

LevelOne
FCS-1030
10/100Mbps IP Network Camera
Quick Install Guide
English
Deutsch
Nederlands
Italiano
Español
Português
Français
Ελληνικά
한국어

日本語
繁體中文
简体中文
Английский
ภาษาไทย
ﻲﺑﺮﻋ
This guide covers only the most common situations. All detail
information is described in the user’s manual.
Viewing System Requirements
 Windows 98, 98SE, Millennium Edition (ME), 2000 and XP
operating systems
 Browser: Internet Explorer 5.0 or above
NOTE:
All the captured images of installation mentioned in this user’s
manual were based on Windows XP operating system. For
installation on other Windows OS, e.g. Windows 98SE, all the
procedures remains the same.

Physical Description
Front panel

Rear panel

Check your package contents
 One FCS-1030 IP Network Camera
 One Camera Stand
 One Power Adapter
 One Software CD
 One Ethernet Cable
Install the camera into the network
Connects the Ethernet cable from RJ-45 socket to a router, a switch,
a Hub or a PC.
Connects the power adapter to the power socket of the FCS-1030 IP
Network Camera and plug the power adapter to the power outlet.
English

Using the Software CD to configure the camera
Power on your PC and insert the CD-ROM
The setup page should load automatically. If it does not, please
select your CD-ROM drive manually to open the setup page.
Click “Install
Software”
Select “Installation
Wizard” to initiate
the installation.

Follow the step to configure the first IP Network Camera that you
have.
Click “Next” to start
the installation.
If you wish to install
the software
program in an
alternate location,
click “Browse”,
otherwise click
“Next” to move on
to the next step.

Click “Next” to
install the software.
Click “Finish” to
complete the
software
installation.

IP Installer screen shall
show up.
The IP Installer will
show a MAC address
and an IP Address of
available FCS-1030.
Highlight the MAC
address and click on
“Link to selected
device”.
After successful linkage,
the authentication
window should pop up.
The default user name
is “root”.
The default password
is the MAC address of
your own FCS-1030,
which marks at the
bottom label of each
device.
Please enter the MAC address in capital letters.

Viewing Your LevelOne FCS-1030
The following
screen would
appear
automatically after
successful login.
Click “Yes” and
proceed.
FCS-1030 should
be active by now.
Congratulations,
you can use the
camera through
the network to
view the video.