LevelOne WBR-6003 User manual

LevelOne
User Manual
Ver. 2.0
WBR-6003
150Mbps N Wireless Router

2
Safety
FCC WARNING
This equipment may generate or use radio frequency energy. Changes or modifications to this
equipment may cause harmful interference unless the modifications are expressly approved in the
instruction manual. The user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
1) Reorient or relocate the receiving antenna.
2) Increase the separation between the equipment and receiver.
3) Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
4) Consult the dealer or an experienced radio/TV technician for help.
CE Declaration of conformity
This equipment complies with the requirements relating to electromagnetic compatibility, EN 55022
class B for ITE, the essential protection requirement of Council Directive 89/336/EEC on the
approximation of the laws of the Member States relating to electromagnetic compatibility.
CE Marking Warning
Hereby, Digital Data Communications, declares that this product (Model-no. WBR-6003) is in
compliance with the essential requirements and other relevant provisions of Directive 1999/5/EC.
The CE-Declaration of Conformity can be downloaded at:
http://www.levelone.eu/support.php
The specification is subject to change without notice.

3
General Public License
This product incorporates open source code into the software and therefore falls under the guidelines
governed by the General Public License (GPL) agreement.
Adhering to the GPL requirements, the open source code and open source license for the source
code are available for free download at http://global.level1.com.
If you would like a copy of the GPL or other open source code in this software on a physical CD
medium, LevelOne (Digital Data Communications) offers to mail this CD to you upon request, for a
price of US$9.99 plus the cost of shipping.

4
Table of Content
TABLE OF CONTENT...............................................................................................................................................................4
1. INTRODUCTION................................................................................................................................................................5
U SER M ANUAL O VERVIEW .........................................................................................................................................................5
2. UNPACKING AND SETUP................................................................................................................................................6
F EATURES ...................................................................................................................................................................................6
P ACKAGE C ONTENTS ..................................................................................................................................................................6
3. HARDWARE INSTALLATION........................................................................................................................................7
F RONT V IEW ...............................................................................................................................................................................7
R EAR V IEW .................................................................................................................................................................................8
H ARDWARE INSTALLATION STEPS ...............................................................................................................................................9
4. CHECK YOUR NETWORK SETTINGS .......................................................................................................................10
5. GETTING START.............................................................................................................................................................11
6. ADVANCED SETUP.........................................................................................................................................................21
B ASIC S ETTING .........................................................................................................................................................................22
Primary Setup.......................................................................................................................................................................23
Static IP Address..................................................................................................................................................................................24
Dynamic IP Address with Road Runner Session Management............................................................................................................25
PPTP.....................................................................................................................................................................................................27
L2TP.....................................................................................................................................................................................................28
Virtual Computers (Only for Static and dynamic IP address WAN type) ............................................................................................29
DHCP Server........................................................................................................................................................................30
Wireless Settings ..................................................................................................................................................................31
Change Password.................................................................................................................................................................41
F ORWARDING R ULES ................................................................................................................................................................42
Virtual Server.......................................................................................................................................................................43
Special AP............................................................................................................................................................................44
Miscellaneous.......................................................................................................................................................................45
Packet Filter.........................................................................................................................................................................47
Packet Filter.........................................................................................................................................................................47
Domain Filter.......................................................................................................................................................................52
URL Blocking.......................................................................................................................................................................53
MAC Address Control..........................................................................................................................................................54
Miscellaneous.......................................................................................................................................................................56
System Time..........................................................................................................................................................................58
System Log ...........................................................................................................................................................................59
Dynamic DNS.......................................................................................................................................................................60
SNMP Setting .......................................................................................................................................................................61
Routing.................................................................................................................................................................................62
Schedule Rule.......................................................................................................................................................................64
Toolbox.................................................................................................................................................................................66
View Log...............................................................................................................................................................................67
Firmware Upgrade...............................................................................................................................................................68
Backup Setting......................................................................................................................................................................68
Reset to Default....................................................................................................................................................................68
Reboot ..................................................................................................................................................................................68
Miscellaneous.......................................................................................................................................................................69
TECHNICAL SPECIFICATIONS...........................................................................................................................................80
Default Settings
IP Address 192.168.1.1
Password admin
Wireless Mode Enable
Wireless SSID LevelOne
Wireless Security None

5
1. Introduction
Congratulations on your purchase of LevelOne WBR-6003 150Mbps N Wireless Router. This product
is specifically designed for Small Office and Home Office needs. It provides a complete SOHO
solution for Internet surfing, and is easy to configure and operate even for non-technical users.
Instructions for installing and configuring this product can be found in this manual. Before you install
and use this product, please read the manual carefully for fully exploiting the functions of this product.
User Manual Overview
Introduction
Describes the 150Mbps N Wireless Router.
Unpacking and Setup
Helps user to get started with the basic installation of the 150Mbps N
Wireless Router.
Hardware Installation
Describes the LED indicators of the 150Mbps N Wireless Router.
Configuration
Describes the functionalities and its settings.
Technical Specifications
Lists the technical (general, physical and environmental)
specifications of the 150Mbps N Wireless Router.

6
2. Unpacking and Setup
This chapter provides the package contents and setup information for the 150Mbps N Wireless
Router.
Features
 Extended and high-speed wireless connectivity with wireless 802.11 N technology
 Advanced QoS Services for Intelligent Internet
 Backward compliant with IEEE802.11G and 11B standards
 Operates on the 2.4GHz frequency band
 Stay Protected with Advanced Network Security
 WEP and WPA/WPA2-PSK encryption supported along with Wi-Fi Protected Setup
 Integrate 4-Port Fast Ethernet Switch with 10/100Mbps MDI-MDI-X auto-sensing
 Built-in NAT function allows multiple PCs and devices to share Internet connection
 Browser-based interface configuration and management
 Quick Setup Wizard provides alternative way to manage device
Package Contents
Open the box of the 150Mbps N Wireless Router and carefully unpack it. The box should contain the
following items:
 WBR-6003 150Mbps N Wireless Router
 Power Adapter
 RJ-45 Cable
 CD Manual / Utility
 Quick Installation Guide
If any item is found missing or damaged, please contact your local reseller for replacement.

7
3. Hardware Installation
Front View
1) Status
•A steady blinking light indicates the device is ready
2) WAN
•A solid light indicates the WAN port is connected.
3) WLAN
•A solid light indicates the Wireless LAN is turned on and ready for use.
•Off indicates Wireless LAN is turned off.
•LED blinks during wireless data transmission.
•Steady blinking indicates WPS function is activated and the router is pairing with wireless client.
4) LAN Lights
•A solid light indicates to an Ethernet enable computer on ports 1 ~ 4.
•LED blinks during data transmission.
5) Wireless On/Off Button/ WPS Button
•Press and hold for 3 seconds to turn the Wireless LAN on or off.
•Please confirm WLAN status as indicated by WLAN Light
•It is also Wi-Fi Protected Setup push button. Press and hold for 1 seconds to activate WPS pairing
with wireless client when WLAN is on.

8
Rear View
1) Antenna
3dBi fix antenna allows users to have a wider range signal coverage.
2) LAN Ports (1~4)
Connect Ethernet devices such as computers, switches or hubs.
3) WAN Port
The WAN port is the connection for the Ethernet cable to the Cable or DSL Modem.
4) Reset Button
It allows user can reset device to Factory Default setting .
4) Power Jack
Receptor for the supplied power adapter

9
Hardware installation steps
Decide where to place your Wireless Router
You can place your Wireless Router on a desk or other flat surface. For optimal performance, place
your Wireless Router in the center of your office (or your home) in a location that is away from any
potential source of interference, such as a metal wall or microwave oven. This location must be close
to power and network connection.
Setup LAN connection
 Wired LAN connection: Connect an Ethernet cable from your computer’s Ethernet port to one of
the LAN ports of the Wireless Router.
 Wireless LAN connection: Locate the WBR-6003 at a proper position to gain the best transmit
performance.
3. Setup WAN connection
Prepare an Ethernet cable for connecting this product to your cable/xDSL modem or Ethernet
backbone.
4. Power on
Connecting the power cord to power inlet and turning the power switch on, this product will
automatically enter the self-test phase. When it is in the self-test phase, the Status indicator will
be lighted ON, and the Status indicator will be continuously flashing once per second to indicate
that this product is in normal operation.

10
4. Check Your Network Settings
1. Please make sure your PC can get IP address automatically so the WBR-6003 can communicate
with your PC during configuration.
•Select “Control Panel” > “Network Connections”.
•Right click the “Local Area Connection” and choose “Properties”.
•Select the TCP/IP protocol for your network card.
•Click on the Properties button. You should then see the following screen and make sure you
have selected “Obtain IP address automatically”
2. Reboot computer to make sure you have received the IP address correctly.

11
5. Getting Start
Setup your CD Easy Setup
Insert the CD into CD-Rom on your PC. The program, AutoRun, will be executed automatically. And
then you can click the Easy setup Icon for this utility.
Configure the settings by the following steps.
1.
Select Language then click “Next” for
continues.
2. Setup mode
You can select Wizard mode to run
the setup step-by-step or run
advanced mode to diagnose the
network settings of the router.

12
3. Advanced mode Setup
Check the PC, Router or Internet
icons for the Status of PC, Router or
Internet.
4.
Quick Wizard Install mode Setup
Make sure the router is powered on.
Make sure your network adapter is
connected to the LAN port of the
router
Make sure your network adapter has
an IP address.
Click “Next” for continues
5. Wireless Setting
Key in the SSID, Channel and
Security options, and then click
“Next” for continues.

13
6. Auto Detect WAN Service
Click “Next” for continue.
Click the button, “Let me select WAN
service by myself”, to disable this
function.
Note: The Item supports to detect the
Dynamic and PPPoE WAN Services
only
Example, the Dynamic WAN type is
detected.
7. Manual select WAN Service
In the manual mode, Click the any
icons for continues.
8. Summary of the settings and Next
to “Reboot”
Click “Next” for continue.

14
9. Apply the Settings or Modify.
Click “Next” for continue.
10. Test the Internet connection.
Test WAN Networking service. Click
“Next” for continue.
You can ignore the by select the
“Ignore Test”.
11. Setup Completed.
The Easy Setup is finish. You can
open the default web browser to
configure advanced settings of the
Router.
Click “Finish” to complete the
installation.

15
Configuration Wizard
Once properly configured, the WBR-6003 150Mbps N Wireless Router will obtain and assign IP
address information automatically. Configuration settings can be established through the Web-Based
Configuration Menu.
Open a web browser (Internet Explorer/Firefox/Safari) and type in the IP Address
http://192.168.1.1
Note:
If you have changed the default IP Address assigned to the WBR-6003, ensure you enter the
correct IP Address.
Type in “admin” (without quotes) in the Password box, Then click Login
Note: admin is the default login password for the unit.
The user can setup step by step to finish the connection with Wizard.
If you are an advanced user, you can access the configurations directly in the Advanced Setup

16
Setup Wizard will guide you through a basic configuration procedure step by step. Press Next to
begin.
Step 1:
Set up your system
password.
Press “Next”

17
Step 2:
Select Wan Type.
Auto Detecting or
Setup Manually.
Press “Next”
Step 3:
Setup WAN Type of your
internet, then press “Next”
Setup the LAN IP, Host
Name information and
WAN Mac address, then
press “Next”

18
Step 4:
If you choose WAN type
of PPP over Ethernet,
please fill in PPPoE
service information which
is provided by your ISP.
After setup, press “Next”
Step 5:
Set up your Wireless
settings, you can
Enable/Disable wireless,
setup SSID information,
and configure wireless
channel in this page.
After setup, press “Next”
Set up your wireless
security encryption. It is
suggest to use WPA-
PSK/WPA2-PSK to have
stronger wireless
encryption.
After setup, press “Next”

19
Step 6:
Check all settings is
correct, then click “Apply
Setting” button.
The device will
automatically reboot to
make the settings effect.
Once the user finishes those steps and the router screen displayed as below. It means that the
Internet connection is now established.

20
System Status
This option provides the function for observing this product’s working status:
WAN Port Status:
If the WAN port is assigned a dynamic IP, there may appear a “Renew” or “Release” button on the
sidenote column. You can click this button to renew or release IP manually.
Wireless Status:
You can check your Wireless settings in this column.
Statistics of WAN:
Enables you to monitor inbound and outbound packets