LEVIOR 70061 User manual

LEVIOR s.r.o.
Troubky č. p. 900
751 02 Troubky
CZ 61973939
WELDING HELMET
70061
INSTRUCTIONS FOR USE
Importer: LEVIOR s.r.o.
!!! WARNING !!!
Before use, carefully read this manual!
Welding masks are designed to protect eyes and face against sparks and harmful radiation under normal
welding. Does not protect you from severe impacts, including flung pieces of crumbling and grinding discs
must never be used for this activity.
This helmet will not protect you from ever explosive devices or corrosive liquids.
Uncovered parts of your body Avoid sparks, splashes and direct and / or scramble radiation. Use adequate
protection for these parts of the body when subjected to such treatment.
INSTRUCTIONS FOR USE
I. PRODUCT FEATURES
- This product is a completely newly designed shell is resistant to low and high temperatures, corrosion, soft
light tightening is highly durable.
- Total protection from UV and IR radiation.
- Fully complies with DIN, ISO, safety standards EN379 and ANSI Z.1-1989.

2
II. OPERATING INSTRUCTIONS
1. From the visor from inside and outside, remove the protective film.
2. Set the clamping Cross:
a. Turn the mask with a cross clamping - the headband so that the adjusting wheel was on the back
of the head. Turn the adjustment knob counterclockwise to increase the circumference of the
cross - headbands. Turn the dial clockwise to decrease the circuit.
b. The upper part of the cross set in order for you the best view through the glass at full seating
of the mask on the head.
c. Loosen the screw that tightens the headband on the right side of the mask and gently pull the
mat. Stop move to any point - will adjust the slope of the cross and at the same time changing the
viewing angle and distance from the eye filter.
d. Tighten the screws tightening headband set the final angle of view through a peephole.
III. SAFETY
-Welding helmet can be used for various types of welding processes.
-The outer part of the filter cartridge must be protected by a protective plate to prevent irreversible
damage.
-As soon replace scratched or broken shield, which reduces the field of view and eye protection.
-Do not store the mask near a source of heat and / or high humidity areas.
-Do not clean the outer shield and the filter cartridge alcohol, petrol, thinner or similar means, and do not
put them in water.
-Regularly replace the fabric for sucking sweat.
IV. MAINTENANCE
-The outer shield and the filter cartridge with a clean soft cloth and spring. To clean the cross-hair bands
use a neutral detergent.
-Provide protection against a blow to the visor and the surrounding area.
WARRANTY
Manufacturer warrants to the purchaser of this product that has no material defects and will function for a
period of two years from the sale of the product to the buyer. The manufacturer has an obligation under this
warranty, replace, repair or refund for a product with defects. This guarantee does not cover malfunction or
damage caused by tampering, misuse or abuse. Please follow these instructions carefully in order to comply
warranty.
Violation of the instructions in this manual will cause the warranty will not be valid. The manufacturer also
not liable for any indirect or consequential damage of product use.
V. TECHNICAL PARAMETERS
Shade number: DIN11
Viewing Area: 113 x 80 mm
Size of helmet: 360x240x190mm
Holder of helmet: Type 05 average 175 –200mm
Optical protection: UV/IR protective glass with a protective layer
UV Transmittance: 0.00006%
780-1300nm 0.003%
IR Transmittance: 780-1300nm 0.003%
1300-2000nm 0.009%
Material: PA (C)
Weight: 530g
Numbers of certificates entitling them to produce: XK20-2060007
XK20-2050023

3