Ins all Mo ion Sensor
1. Remove the Motion Sensor and related components from
the box and physically install the device according to the
manufacturer's printed instructions.
2. Once the Motion Sensor has been mounted to a flat
surface and installed according to the manufacturer's
recommendations, move to the next step.
Add he Mo ion Sensor o he LifeShield
Sys em
Starting with the Motion Sensor attached to a flat surface...
1. On the Handset or Console, press MENU.
2. Scroll to Security Setup, press SELECT and enter the
Master Code.
3. Scroll to Sensors, press SELECT.
4. Scroll to <Add New>, press SELECT.
5. Scroll to Motion, press SELECT.
6. Following the instructions displayed on the LCD screen:
- Wait 5 seconds then detach (remove) the Front Cover of the
Motion Sensor as illustrated in the manufacturer's printed
instructions ("Un-clip Sensor from Bracket"). (You will have
30 seconds to complete this step.)
When the Motion Sensor has successfully been added you will
hear 4 fast confirmation beeps from the LifeShield system. If
there are no confirmation beeps, check to make sure that the
battery insulator tab has been removed, re-attach the Front
Cover and repeat the steps above.
NOTE: It is important to follow the manufacturer's printed instructions regarding
(a) battery installation and activation, (b) setting adjustment, (c) mounting and
installation and (d) range adjustment (walk test) prior to moving on to the next step
involving integration of this device with your LifeShield system. lease note that it
is not necessary to " ROGRAM" the device at this time.
Once the Motion Sensor has been added to the LifeShield
system:
7. Use the Edit feature to rename the device (if desired).
( ress DELETE to erase text and the keypad keys to type
new ones).
8. ress OK, then press BACK until the Main Menu is
displayed.
9. Re-attach the Front Cover of the Motion Sensor.
Tes he Mo ion Sensor
1. Move away from the area that is in direct line of sight of
the Motion Sensor (move to an adjacent room). Wait
3 minutes.
2. On the Handset or Console, press MENU
3. Scroll to Utilities, press SELECT
4. Scroll to Test, press SELECT
5. Enter your Master Code
6. Select System Test
7. ress the SKI soft key to skip the Siren Test
8. ress the OK soft key on next screen for Starting
9. Scroll to the name of the Sensor that you would like to
test, and press SELECT
10.Move back into the line of sight of the Motion Sensor
(this will trigger the device).
If the Motion Sensor test is successful, the LCD screen will
display “Sensor xxx assed”. If these words do not appear,
return to “Add the Motion Sensor to the LifeShield System”.
NOTE: If you require additional assistance with setup or installation, please
contact LifeShield Customer Support at 1-888-392-2044.
